INSTALLATION
XL5000
M02001102EN0319
33
4.2.3
Establishing the compressed air connection
Step 1: Establishing the compressed air supply connection
Connect the compressed air supply connection on the pneumatic service unit to the compressed air supply. Use a flexi-
ble air tubing with an external diameter of 6 mm.
Step 2: Establishing the compressed air connection to the printer
Connect the air supply connection on the pneumatic service unit to the compressed air connection of the printing sys-
tem. Use a flexible air tubing with an external diameter of 6 mm.
When installing the pneumatic service unit, please follow the instructions under "
Mechanical
installation
".
4.3
Communication via the serial interface (RS-232)
Use the supplied connection cable to connect the printing system to a computer or the control terminal
a:touch 2
via
the serial interface. If you use a different connection cable, please observe that the cable must be appropriately
screened for safe operation and that the maximum permissible length defined in "
Mechanical
data
" may not be ex-
ceeded.
The following settings must be used in the software for communication via the serial interface:
Data bits
8
Parity
None
Baud rate
115200
Stop bits
1
Flow control
None
If XL5000 is selected as printer type in the
a:control
software, these settings are automatically adopted under
Serial
connection
. For further information about the
a:control
software, please refer to the corresponding manual.
4.4
Communication via the Ethernet connection
Use the supplied network cable to connect the printing system to a computer or the control terminal
a:touch 2
. If you
use a different network cable, please observe that the cable must be appropriately screened for safe operation and that
the maximum permissible length defined in "
Mechanical
data
" may not be exceeded.
In the condition as supplied, the settings of the printing system are defined as follows for communication via network:
IP address
192.168.1.254
Subnet mask
255.255.255.0
Port
30001
NOTE
Compressed air supply
Switch on the compressed air supply with the recommended value (see "
Connection possibilities and
connection of components
") before you switch on the printing system.
Summary of Contents for XL5000 OPPOSITE
