Allen-Bradley 1407-CGCM, User Manual, Page: 146 / 252

Rockwell Automation Publication 1407-UM001H-EN-P - November 2014
#HAPTER CGCM Unit Software Interface
!SSEMBLY/BJECT)NSTANCE#ONFIGURATION$ATA4ABLE
The Get Attributes Single service for instance 4 of the Assembly Object can
access the following information.
The Set Attributes Single service for instance 6 of the Assembly Object can access
the following information.
#ONFIGURATION#HECKING
When configuration data is received, the CGCM unit verifies that individual
parameters are within the minimum and maximum values indicated in the table
below (for example, perform range checking). If an out-of-range parameter is
detected, the CGCM unit enters a configuration fault mode and ignores all data
in the configuration write. The Connection tab in the module configuration
dialog box in RSLogix 5000 software displays an error code corresponding to the
first offending configuration parameter. The CGCM unit
does not perform any
application checking (for example, is a value suitable for the particular
application) or dependency checking (for example, is a value reasonable based on
other values entered).
$ATA4ABLE
)-0/24!.4 Writing the CGCM unit’s configuration with unscheduled messaging is
not recommended. We recommend using only scheduled configuration
messaging sent when the connection is opened or the module
configuration is edited in RSLogix 5000 software.
4ABLE'ET!TTRIBUTES3INGLESERVICECODEX%
.AME !TTRIBUTE)$ $ATA4YPE 6ALUE
Data 3 UINT See Unscheduled Configuration
Read/Write Data Table,
Assembly Instance 4
Size 4 UINT 344
4ABLE3ET!TTRIBUTES3INGLESERVICECODEX
.AME !TTRIBUTE)$ $ATA4YPE 6ALUE
Data 3 UINT See Unscheduled Configuration
Read/Write Data Table, Assembly
Instance 4
)-0/24!.4 Use of this service is not recommended. See the note above.