Alamo Industrial Traxx RF, Operator'S Manual

Page: 141 / 212

OPERATION
TRAXX RF 04/14 Operation Section 4-35
© 2014 Alamo Group Inc.
OPERA
T
ION
Thread the 12mm hexhead capscrew into the
manual brake release hole until it bottoms out in
the hole.
Make sure the support plate is supported by the
motor housing.
Do not over tighten the hexhead capscrew into the
hole.
Move the washer down the shank of the screw and
thread the nut down until it is in firm contact with
the metal support plate.
Use a suitably sized wrench to slowly tighten the
nut against the washer and the support plate.
Tightening the nut will gradually pull the hexhead
capscrew out and pull the brake plates away which
will release the brake. Turn the nut until it tightens
against the plate and will no longer turn.
Stop when resistance prevents further movement;
Do Not Overtighten the nut.
Repeat the procedure for both wheel motors (right
and left).