Alamo Industrial Traxx RF, Operator'S Manual

Page: 102 / 212

ASSEMBLY
TRAXX RF 04/14 Assembly Section 3-4
© 2014 Alamo Group Inc.
ASSEMBL
Y
The fluids of the TRAXX RF were checked and topped off prior to shipping.
• You should check the engine oil before starting the machine.
• The dipstick is on the left hand side of the engine.
• There is ample diesel fuel in the fuel tank for removal.
Insert the key into the control panel and turn it to the run position.
"The remote has to communicate with the receiver on the TRAXX RF.
"Be sure the key on the remote is on. It is located on the bottom left side.
The emergency stop switches on the remote and the TRAXX RF must be pulled out, into the "ON"
position.
• These stop switches must be twisted approximately 1/8-turn counterclockwise before they will pop
out.
Communication must be confirmed by sounding the horn.
• The horn button is on the underside of the remote. It is a green button.
• The engine will not start if the horn has not sounded.
Press the start button on the remote.
• It is typical for the mower not to start on the first try of a cold start.
Before backing the unit out of the crate it is crucial that you raise the head enough to clear
the chock blocks which are at the front of the tracks.
After you have completed these steps you will be able to go through any pre-operation procedures outlined in
the owner's manual. For any further operation consult the owner's manual.