Advantech ADAM-5000/TCP Series, Manual

Page: 52 / 341

System Hardware Configuration
Chapter 5
Step2: Click the Network tip to configure the TCP/IP network setting
Figure 5-7: TCP/IP Network setting
MAC Address: This is also called Ethernet address and needs no
fur- ther configuration.
Link Speed: This function will show the current linking speed to be
either 10Mbps or 100Mbps. However, the utility will auto-
detect the current transmission speed on the network
segment and set the transmission speed for the device
accordingly without your further efforts.
Duplex Mode: The utility will detect the current transmission mode
(half-duplex or full-duplex) on the network segment, and
set the transmission mode for the device accordingly
without your further efforts.
IP Address, Subnet Mask, Default Gateway : The IP address identifies
your ADAM-5000/TCP Series device on the global network. Each
ADAM-5000/TCP has same default IP address 10.0.0.1. Therefore,
please do not initial many ADAM-5000/TCP Series at the same time to
avoid the Ethernet collision.
If you want to configure the ADAM-5000/TCP Series in the host PC’s
dominat- ing network, only the IP address and Subnet Mask will need to
set ( host PC and ADAM-5000/TCP Series must belong to same subnet
Mask). If you want to configure the ADAM-5000/TCP Series via
Internet or other net- work domination, you have to ask your network
administrator to obtain a specific IP and Gateway addresses then
configure each ADAM-5000/ TCP Series with the individual setting.
ADAM-5000/TCP User’s Manual 5-7