58
Futuresun HP V2
Lower the sunbed acrylic in such a way that it rests
safely on the support bar.
Take off the front cover plate as described on page
21.
Pull out the used dust filter.
Push in the new dust filter. Start in the center and
push between the two profile bars.
Remount the front cover plate.
Lift the front cover plate for a few centimeters.
To put in the support bar, lift it slightly up and turn it
to down to the left hand side.
Put the sunbed acrylic onto the sunbed.
Dispose of used dust filters according to
environmental regulations.
Replacement of Show-lights
The top backlighting and the LED backlighting of
the front cover plate must be replaced whenever the
lamps or LEDs are defective.
LED backlighting of sunbed
Two LED lights are positoned in the front cover plate.
These are fixed with a screw each to a holding plate
at the front cover plate. This holding plate is located
at the interior front cover plate. To replace the LED
backlights, proceed as follows:
Deactivate the mains disconnection switch and
secure with lock and key against accidental
activation.
Keep some soft support material ready for storage
of the sunbed acrylic.
Lift up the sunbed acrylic (1).
Lift up the support bar (2) and push it slightly
downward (3).
Lower the sunbed acrylic carefully so that it can
rest on the support bar.
Remove the front cover plate as described on page
21.
Put the front cover plate upfront on a soft level
support.
Use a screwdriver to loosen the screws at the lamp
wire connector.
Pull the wires out of the lamp wire connector.
Summary of Contents for Future Sun HP
Page 72: ...72 Futuresun HP V2 ...
Page 73: ...73 Futuresun HP V2 ...
