36
Futuresun HP V2
Put the ramps for the guide rails close to the guide
rails of the sunbed.
In order to put the ballast tray into the sunbed, two
persons slightly lift the ballast tray.
Put the ballast tray onto the ramps and then move
it carefully into the sunbed.
Assembly of air vents to the sunbed
At the headend of the sunbed are two air vents, at the
footend there are three air vents..
If the unit is equipped with the optional
active shoulder tanner, the two air vents
for the headend are not provided.
Use a screwdriver to fasten the air vents at the
head- and footend.
Assembly of top canopy
WARNING
RISK OF BRUISES!
When assembling the top
canopy there is a risk of
bruising your hands. When
lifting the top, do not hold
on to hinge brackets!
WARNING
RISK OF HEAVY
LOAD!
Carrying the heavy sunbed
components can lead
to overstrain and health
problems.
Always carry the heavy
sunbed components with
four persons.!
After preparing the electrical connection, the top
canopy can be reassembled.
Proceed as follows:
Lift the top canopy with 4 persons.
A fifth person has to carry the cables to be fed into
the sunbed from the rear side.
Let the top canopy rest with the hinge brackets in
level position above the bearings.
Summary of Contents for Future Sun HP
Page 72: ...72 Futuresun HP V2 ...
Page 73: ...73 Futuresun HP V2 ...