52
Futuresun HP V2
left hinge endcap
When you need to replace the sunbed acrylic, you
need to loosen the hinge profile from the sunbed after
removal of the sunbed acrylic. Proceed as follows:
Get a soft support for storage of the sunbed acrylic
ready.
Lift the top canopy.
Two persons lift the sunbed acrylic for about 12”
(1) and take it out pulling the acrylic to the front(2).
Store the sunbed acrylic on a soft support. To
loosen the hinge profile, pull the right and left joint
from the hinge profile (1).
Pull the fixing shaft out of the
hole in the sunbed acrylic (2).
Take the hinge profile off the sunbed acrylic.
Push the hinge profile onto the new sunbed acrylic.
Put the fixing shafts through the holes in the
sunbed acrylic (1).
Put the right and left joint onto the hinge profile (2).
Clean and disinfect the new sunbed acrylic with a
suitable special acrylic cleaner .
Two persons put the acrylic into the holding at the
sunbed (1).
Lower the sunbed acrylic carefully (2).
Summary of Contents for Future Sun HP
Page 72: ...72 Futuresun HP V2 ...
Page 73: ...73 Futuresun HP V2 ...
