6247G/6247C DC Voltage Current Source/Monitor Operation Manual
2.2.3 Menu Operation
2-32
1) OPR Signal
INTERLOCK/OPERATE IN/OUT control signal function
setting
STBY In/IntrLock In/Operate Out/OPR/SUS In
OPR/STBY In
Select
2) Cmpl/Sync
COMPLETE OUT/SYNC OUT control signal function set-
ting
Meas Front/Meas End/Comp HI/Comp GO/Comp LO/
Comp HIorLO/Sync Out
Select
3) Sig Width
Control signal output pulse select
10
s/100
s
Select
Category level Select
level Input/Run
level
K) PARAMETER
Parameter
types
1) Param Load
Loads the saved parameters.
Load0/Load1/Load2/Load3/Ld Dflt
Select the parameter above and press [ENTER] to run.
Run
2) Param Save
Saves the setting parameters.
Save0/Save1/Save2/Save3/Sv Dflt
Select the parameter above and press [ENTER] to run.
Run
3) PON. Load
Parameter load at power on.
P.OFF/Load0
Select
(d)
L) I/F
1) I/F BUS
Interface
6247G GPIB/USB
6247C USB/RS-232
Select
2) GPIB Adr
GPIB address
When GPIB is selected
0 to 30
Numeric
2) USB Id
USB ID
When USB is selected
1 to 127
Numeric
3) Header
Header
On/Off
Select
4) Talk Only
Addressable/Talk Only
When GPIB or RS-232 is selected
Off/On
Select
5) Baud Rate
Baud rate
When RS-232 is selected
19200/9600/4800/2400/1200/600/300
Select
6) Data Bit
Number of data bits
When RS-232 is selected
8 bit/7 bit
Select
7) Parity
Parity
When RS-232 is selected
NONE/ODD/EVEN
Select
8) Stop Bit
Number of stop bits
When RS-232 is selected
1 bit/2 bit
Select
J) EXT SIGNAL
(e)
