583
System CMOS checksum
bad - Default
configuration used
System CMOS has been corrupted or modified
incorrectly, perhaps by an application program
that changes data stored in CMOS. The BIOS
installed Default Setup Values. If you do not
want these values, enter Setup and enter your
own values. If the error persists, check the
system battery or contact your dealer.
System timer error
The timer test failed. Requires repair of system
board.
Real time clock error
Real-Time Clock fails BIOS hardware test. May
require board repair.
Check date and time
settings
BIOS found date or time out of range and reset
the Real-Time Clock. May require setting legal
date (1991-2099).
Previous boot incomplete
- Default configuration
used
Previous POST did not complete successfully.
POST loads default values and offers to run
Setup. If the failure was caused by incorrect
values and they are not corrected, the next boot
will likely fail. On systems with control of
wait
states
, improper Setup settings can also
terminate POST and cause this error on the next
boot. Run Setup and verify that the waitstate
configuration is correct. This error is cleared the
next time the system is booted.
Memory Size found by
POST differed from CMOS
Memory size found by POST differed from
CMOS.
Diskette drive A error
Diskette drive B error
Drive A: or B: is present but fails the BIOS POST
diskette tests. Check to see that the drive is
defined with the proper diskette type in Setup
and that the diskette drive is attached correctly.
Incorrect Drive A type -
run SETUP
Type of floppy drive A: not correctly identified in
Setup.
Incorrect Drive B type -
run SETUP
Type of floppy drive B: not correctly identified in
Setup.
BIOS Message
Description
Summary of Contents for AB460 F1
