Product Guide - A5000 R5.4 – Aastra X series
BPS0121AENAA01
Page 32/74
5.3.7.3 Inputs/outputs
The cabinet is available in the following format: RJ45 outputs
The following inputs/outputs exist on the front panel of each UCV2L motherboard:
•
1 DB9 connector for the debug link
•
1 DB25 connector for alarms and remote controls
•
1 RJ45 socket for connecting external on-hold music
•
2 RJ45 sockets for the primary and secondary DECT synchronisation ports
•
3 Ethernet ports (10/100 base T)
•
On UCV1L: 3 USB ports, one master and two slaves. On UCV2: 2 USB ports, slaves
•
control LEDs
•
the NMI/reset buttons
•
On UCV1L: 1 RJ45 port for connecting the printer (printer port not active from R5.1). This port
doesn’t exist on UCV2L
The following inputs/outputs exist on each power supply module, on the cabinet’s front
panel:
•
the 220V 50Hz mains connection socket
The following connectors are located at the back side of the cabinet:
•
A connector for expansion cabinet
•
A connector for battery’s link.
5.3.7.4 UCV2L motherboard
The basic cabinet contains the main UCV2L card, including:
•
1 control unit
•
3 Ethernet 10/100 BASE TX accesses
•
1 32-trunk matrix with dynamic addressing
•
1 voice mail system with 8 access points
•
1 Compact Flash Card (software of the Gateway and terminals, configuration’s data…); the
capacity of the COMPACT flash allows a new software release, a new firmware release of the
IP/SIP terminals to be downloaded and the buffer function (for tickets and billing) to be
integrated and the pictures storage. From version R5.1C, the memory size is 2Go. A new 4Go
compact Flash card is available with R5.4.
•
8 3-way conference circuits
•
4 alarm loop inputs and 4 alarm loop outputs
•
1 HDLC controller for setting up data communication in a B channel
•
1 voice prompt and synchronised announcements (on-hold, pre-off-hook)
The UCV2L card provides the interfaces with the following components:
•
one debugging console for the UCV2L card (1 DB9 console connector)
•
On UCV1L: 1 RJ45 port for connecting the printer (printer port not active from R5.1). This port
doesn’t exist on UCV2L
•
an external music source (RJ45 socket)
•
a general bell
•
alarm inputs (4)
•
Ethernet network: Ethernet 10/100 BASE TX accesses (1 LAN RJ45 connector), allowing the
connection of IP/SIP terminals, SIP Trunk network, i2070, TWP applications in CTI mode (VTI-
XML protocol), administration, etc.
•
the RUCV card of an expansion cabinet
