Product Guide - A5000 R5.4 – Aastra X series
BPS0121AENAA01
Page 12/74
Analogue network lines:
LR4
4 analogue network lines. It can also be fitted with tone detection (DTOC) or billing
(FTXA or FTXC) daughter boards.
LI1
This card is used to interconnect 2 private iPBXs through an analogue tie line.
Digital interfaces and ISDN
LD4N/LD4X
4 S0/T0 ISDN interface card used to connect either 2/4-channel DECT base
stations, or ISDN terminals (S0), or an ISDN BRI interface (T0).
LD4/LD4N/LD4X
+ 1 ADPCM16
Adding the ADPCM16 daughterboard allows you to manage four 4-channel DECT
base stations.
LT2
S2/T2 ISDN primary rate or PCM interface.
used to connect either to one primary access of a European ISDN network (32IT)
or an American ISDN network (T1, 24IT), or an S2 bus or a PCM digital link
(S2/T2) channel by channel (CAS Channel Associated Signalling).
Data interfaces
CA1
This card used to connect V24 computer terminals (DTE or DCE) in V10 or V28
mode (RS232C). Its front panel has 4 RJ45 ports used to connect 4 asynchronous
terminals for data transmission (max. speed: 19200 bits/s).
CS1
This card used to connect two X.25 synchronous interfaces in V28 or V10 mode,
thanks to 2 DB25 connectors
PT2
TCP/IP and voice over IP gateway card used for connection to a 10/100Mbits
Ethernet LAN compliant to the IEEE 802.3 specifications (RJ45 port).
This card provides
a "TCP/IP – internal buses" gateway function for signalling
a "voice over IP" gateway function. . It is capable of managing 8, 16 or 32 VoIP
gateway channels through the addition of an optional VoIP daughterboard which
carries out the tasks of speech signal processing.
Service cards
IPS
RJ format card which implements a SIP signalling proxy. The SIP access point can
be activated on either the motherboard or the IPS card. The IPS card must be
used if a Session Border Controller (SBC) is required
.
Daughter Boards
ADPCM16
This daughterboard is used to increase from two to four simultaneous
communications on the DECT base stations connected to the UCV2S. Up to 4
DECT base stations can be connected to the motherboard. Fitting the optional
ADPCM16 card on the motherboard makes it possible to manage by default the
four-channel DECT base stations and the handover function between these base
stations,
so
you
do
not
need
to
buy
an
LD4
card.
For AXS
EIP 4/8/32/64
EIP boards allow managing the RTP flows. They have more functionalities than
the VOIP boards (below), such as the T38 fax.
The UCV motherboard can be fitted with two VoIP daughterboards available in
different formats: 4, 8, 32 or 64 voice channels: EIP4, EIP8, EIP32 and EIP64
(attention, EIP64 requires hardware version of UCV2 motherboard). Possible
configurations: 4, 8, 12, 16, 32, 36, 40, 64 and 68, 72, 96 and 128 simultaneous
calls
VOIP 8/16/32
The PT2 card can be fitted with one VoIP daughterboard available in three formats
with 8, 16 or 32 voice channels
