3Com Router 5000/6000 Family
77
Command Reference
hwatacacs change-password self
Use the
hwtacacs change-password self
command to enable the TACACS online user to change the
password.
User view
hwatacacs nas-ip
Use the
hwtacacs nas-ip
command to specify the source address of the hwtacacs packet sent from NAS.
System view
hwatacacs scheme
Use the
hwtacacs scheme
command to enter Server view. If the specified server
scheme does not exist, you can create a new scheme.
System view
hwping
Use the
hwping
command to create an HWPing test group.
System view
hwping-agent enable
Use the
hwping-agent enable
command to enable the HWPing client function.
System view
hwping-agent max-requests
Use the
hwping-agent max-requests
command to set the allowed maximum number of concurrent tests.
System view
hwping-server enable
Use the
hwping-server enable
command to enable HWPing Server.
System view
hwping-server tcpconnect
Use the
hwping-server tcpconnect
command to create a TCP listening service.
System view
hwping-server udpecho
Use the
hwping-server udpecho
command to create a UDP listening service.
System view
icmp redirect send
Use the
icmp redirect send
command to enable the sending of ICMP Redirect messages.
System view
id-type
Use the
id-type
command to select the type of ID used in IKE negotiation.
IKE-Peer view
idle-mark
Use the
idle-mark
command to set the line idle-mark of the synchronous serial interface to “FF”.
Synchronous Serial Interface view
idle-timeout
Use the
idle-timeout
command to set the idle-timeout timer. When it expires, the user connection is
disconnected.
User Interface view
idlecode (CE1/PRI Interface)
Use the
idlecode
command to set the line idle code on the CE1/PRI interface. Two types of line idle code
are available: 0x7e and 0xff.
CE1/PRI Interface view
idlecode (CT1/PRI Interface)
Use the
idlecode
command to set the line idle code on the CT1/PRI interface. Two types of line idle code
are available: 0x7e and 0xff.
CT1/PRI Interface view
if-match
Use the
if-match
command to define the match rule of a class.
Class view
if-match acl
Use the
if-match acl
command to define ACL match rule.
Class view
if-match acl
Use the
if-match acl
command to set conditions that multicast packets should meet in each policy node.
Route-Policy view
