62
3Com Router 5000/6000 Family
Command Reference
display x25 x2t switch-table
Use the
display x25 x2t switch-table
command to display the dynamic switching routing table and
static routing table.
Any view
display x25 xot
Use the
display x25 xot
command to view XOT link information.
Any view
dl-bits
Use the
dl-bits
command to configure the bit value of all the signals of R2 line signaling.
R2 CAS view
dlsw bridge-set
Use the
dlsw bridge-set
command to configure the bridge group to connect DLSw. Use the
undo dlsw
bridge-set
command to delete the bridge.
System view
dlsw enable
Use the
dlsw enable
command to enable DLSw performance.
System view
dlsw ethernet-backup enable
Use the
dlsw ethernet-backup enable
command to enable DLSw Ethernet redundancy.
Ethernet Interface view
dlsw ethernet-backup map
Use the
dlsw ethernet-backup map
command to enable the Ethernet switch support feature for DLSw
Ethernet redundancy, that is, to map the MAC address of a remote SNA device to a local virtual MAC
address.
Ethernet Interface view
dlsw ethernet-backup timer
Use the
dlsw ethernet-backup timer
command to configure the time for which the master DLSw router
waits before sending a positive or negative response to the slave DLSw router upon receipt of a circuit
establishing request.
Ethernet Interface view
dlsw ethernet-frame-filter
Use the
dlsw ethernet-frame-filter
command to apply an ACL in the transmitting and receiving
directions of DLSW module towards bridge module so that it can transmit and receive only the Ethernet
frames with permitted source MAC addresses.
System view
dlsw filter acl
Use the
dlsw filter acl
command to specify to filter packets from any peer.
System view
dlsw local
Use the
dlsw local
command to create the DLSw local peer.
System view
dlsw max-transmission
Use the
dlsw max-transmission
command to set the maximum number of the attempts to send an explorer
frame.
System view
dlsw multicast
Use the
dlsw multicast
command to enable the multicast function of DLSw2.0.
System view
dlsw reachable
Use the
dlsw reachable
command to configure locally reachable MAC and SAP addresses.
System view
dlsw reachable-cache
Use the
dlsw reachable-cache
command to add the reachability information of the specified SNA device
to the reachable-cache. You can specify this SNA device by specifying its MAC address and IP address of
the router to which it is connected.
System view
dlsw remote
Use the
dlsw remote
command to create the DLSw remote peer.
System view
