3Com Router 5000/6000 Family
63
Command Reference
dlsw remote
Use the
dlsw remote
command to create a remote DLSw peer and specifies its version and filtering rule.
System view
dlsw reverse
Use the
dlsw reverse
command to convert a MAC address from Ethernet order to token ring order or vice
versa.
System view
dlsw timer
Use the
dlsw timer
command to configure the DLSw timer parameters.
System view
dns domain
Use the
dns domain
command to configure a DNS domain name.
System view
dns-list
Use the
dns-list
command to configure DNS server IP addresses in a global DHCP address pool.
DHCP Address Pool view
dns-proxy enable
Use the
dns-proxy enable
command to enable DNS proxy.
System view
dns resolve
Use the
dns resolve
command to enable DNS resolving.
System view
dns server
Use the
dns server
command to configure IP address of a DNS server.
System view
domain
Use the
domain
command to configure an ISP domain or enter the view of an existing ISP domain.
System view
domain-authentication-mode
Use the
domain-authentication-mode
command to configure IS-IS route area to authenticate the received
Level-2 routing packets (LSP, CSNP, PSNP), according to the pre-defined mode and password.
IS-IS view
domain-id
Use the
domain-id
command to specify domain ID for a VPN instance.
OSPF Protocol view
domain-name
Use the
domain-name
command to configure the domain name that a global address pool of the DHCP
server allocates to clients.
DHCP Address Pool view
dot-match
Use the
dot-match
command to configure dot match rules of the number-substitute rules.
Voice Number-Substitute view
dpd
Use the
dpd
command to reference a DPD structure.
IKE Peer view
dscp media
Use the
dscp media
command to set the DSCP value in the ToS field in the IP packets that carry the RTP
stream of the voice entity.
Voice Entity view
dsl link-check
Use the
dsl link-check enable
command to enable retraining upon detection of a major fault after the
DSL interface comes up.
ATM (G.SHDSL) Interface view
dtmf
Use the
dtmf
command to configure the way of sending and receiving R2 signaling.
R2 CAS view
dtmf sensitivity-level
Use the
dtmf sensitivity-level
command to set the detection sensitivity level of DTMF codes.
Voice Subscriber-Line view
