66
3Com Router 5000/6000 Family
Command Reference
em-phy-parm
Use the
em-phy-parm
command to configure a wire scheme for the analog E&M subscriber-line.
Voice Subscriber-Line view
em-signal
Use the
em-signal
command to configure a voice subscriber-line start mode.
Voice Subscriber-Line view
enable
Use the
enable
command to enable current aggregation mode.
NetStream Aggregation view
enable deactivate
Use the
enable deactivate
command to enable the router to actively deactivate the BSV interface.
BSV Interface view
enable snmp trap undown
Use the
enable snmp trap updown
command to enable the interface to send UPDOWN traps.
Interface view
encapsulation
Use the
encapsulation gre
command to set the MR encapsulation mode to GRE.
MR view
encapsulation
Use the
encapsulation
command to specify ATM AAL5 encapsulation type for PVC.
PVC view
encapsulation-mode
Use the
encapsulation-mode
command to set the encapsulation mode that the security protocol applies to
IP packets, which can be transport or tunnel.
IPSec Proposal view
encrypt-card backuped
Use the
encrypt-card backuped
command to enable backup function for the encryption card.
System view
encrypt-card fast-switch
Use the
encrypt-card fast-switch
command to enable the fast forwarding function of the encryption card.
System view
encryption-algorithm
Use the
encryption-algorithm
command to specify the encryption algorithm for an IKE proposal.
IKE Proposal view
entity
Use the
entity
command to configure a voice entity and enter its view (at the same time specify the working
mode related to voice).
Voice Dial Program view
error-diffusion restraint config
Use the
error-diffusion restraint config
command to set the three parameters for error diffusion
restraint function.
System view
error-diffusion restraint enable
Use the
error-diffusion restraint enable
command to enable error diffusion restraint.
System view
escape-key
Use the
escape-key
command to define an escape key or key combination for aborting tasks.
User Interface view
esis
Use the
esis
command to employ ES-IS protocol globally and enter ES-IS view.
System view
esis enable
Use the
esis enable
command to employ ES-IS protocol on the interface.
Interface view
esp authentication-algorithm
Use the
esp authentication-algorithm
command to set the authentication algorithm used by ESP.
IPSec Proposal view
