44
Transportation
Motorcycle cleaning
Clean the motorcycle
Clean the motorcycle accord with the following:
1.Use cold water to wash away dirt and mud on the surface of the motorcycle. You can use the
soft sponge or soft brush to clean. You could scratch appearance parts with hard materials to clean.
2.Use neutral detergent or a motorcycle wash soap, thoroughly clean sponge or soft cloth
motorcycle. Sponge or soft cloth should be frequent infiltrate cleaning agent.
Motorcycle waxing
After cleaning, it is recommended that the waxing polishing, which not only it can protect the parts,
but also it makes the parts more beautiful.
Use high quality wax and polish
When using wax and polish wax and polish matters, you need to pay attention on the use
instruction of the products.
Inspect the problem after the use of the motorcycle accord with the instruction.
If you use the motorcycle in salt road surface or the beach, after use, you should wash it in cold
water immediately. You must use cold water. Hot water will accelerate corrosion.
Avoid spray cleaning, avoid water flow to the following location:
Ignition lock
Ignition plug
Fuel tank lock
Fuel injection system
Braking fluid tank
Don’t use high-pressure water to clean the motorcycle,throttle body and oil injector.
After cleaning motorcycle or rain when you drive, there will be water mist in headlamps. Open the front light,
water mist will gradually dissipate. Start the engine to power the headlamps; clear water to avoid the battery
discharge.
When you cleaning the motorcycle, don't use cleaner containing alkaline and acidic detergent, do not use
gasoline, brake fluid, or other solvents which can damage the motorcycle. You can only use soft cloth with neutral
detergent with warm water.
It is very dangerous to drive a motorcycle when the brake is wet. Wet brake is unable to provide braking force
such as dry brake. This can cause an accident. After cleaning the motorcycle, you can test the brake system with
low speed. If needed, operate brake for several times to make brake dry.
Motorcycle
fuel must be discharged before transport. Fuel is easy to combust and under certain
conditions it can cause explosion. When drain the fuel, storage fuel or injected fuel, it is forbidden to
open fire, be sure to stop the engine, to operate in a well-ventilated place. Drain fuel as follows.
(1)
Stop engine rotation, and shut down the electrical door lock switch.
(2) With the method of the siphon or other appropriate approach to pull out fuel from the fuel tank
and put into the appropriate containers.
Inspection after cleaning
In order to prolong the service life of the motorcycle, lubricate the motorcycle according to the
instruction.
3.After cleaning the surface dirt, use water to rush residual cleaning agents.
4.After rinse, wipe the motorcycle with wet soft leather or cloth, and dry in the shade.
5.Carefully check the paint surface. If it has any damage, follow these steps, use repair material
to repair the damage surface:
a. Clean and dry the area of damage.
b. Stir repair material and use small brush to smear lightly at the site of the injury.
c. Thoroughly dry the patch.
When shipping the motorcycles, the fuel in the fuel tank must be discharged clean to prevent fuel leakage and
explosion .The vehicle should be shipped in a normal riding posture to prevent oil leakage from the outlet of the
reducer box during shipping.
Содержание VX 350
Страница 1: ......
