Zontes VX 350, Руководство пользователя

Страница: 26 / 50

24
Air filter
The air filter is located below the seat. If the air filter is dirt jam, it can make the air intake
resistance increases, the output power down, and fuel consumption increases. If driving in dusty
conditions, you should increase air cleaner filter cleaning or replacement frequency. Complete the
following steps to check clean air filter.
Under normal circumstances, the air filter element needs to be replaced or maintained every 10,000km. The air
filter has a quick maintenance function. After the quick maintenance, you can continue to drive for 4,000km before
continuing to maintain or replace the filter element.
If driving in dusty conditions, you should clean or replace the filter more often.
It is dangerous to run the engine without the air filter installed. Without the blockage of the inner filter element
of the air filter, the flame of the engine will be sprayed back from the engine to the intake cavity of the air filter. Dirt
can get inside the engine and cause damage to the engine. Do not run the engine without the air cleaner element.
If the air cleaner filter installation position is not correct, the dust will bypass the filter into the engine which
can damage the engine. Make sure the filter installed in the correct position. In addition, when you flush the
motorcycle, don't let the water into inside the air filter; if there is water into the air filter, you can pull the release
the product oil pipeline, and make sure there was no swelling in the empty filter before using the motorcycle.
Product oil pipeline
1. As shown in Figure 4, remove the left cover (refer to step 1 of removing the fuel tank).
2. As shown in Figure 5, after removing the left cover, remove the clamp with needle-nose pliers,
drain off the waste oil, and then install it back to its original state in reverse order.
Maintenance/replacement of oil filter element:
1. As shown in Figure 1, remove the 4 hexagon socket head bolts on the left and right sides, and
take off the electrical device box cover.
2. As shown in Figure 2, first remove the two nuts and put down the charging socket. Remove the
two screws and take out the air filter rear cover.
3. As shown in Figure 3, pull out the oil filter element (note: please see the official website video
for details).
4. Observe the extracted oil filter element, and use a high-pressure air gun to blow off the
contaminants from the clean side. If there is serious pollution or damage, the oil filter element must
be replaced.
5. Install the restored vehicle in reverse order.
1
4 5
2 3