37
Lighting and Signaling
Please refer to the instruction of the front part “check before driving” for the illumination and signal
inspection.
Front brake switch
Rear brake switch
Front brake switch
The front brake switch, housed in a former brake controller. When you slightly feel pressure before
holding brake controller, the brake light is up.
The rear brake switch located in the bolt of brake hose. When you feel the pressure on the rear
brake pedal slightly, the brake lights up.
Rear brake switch
Lamp bulb change
We use imported LED light product for the front light. In that case, we don't need to replace the
lamp bulb during the usage life of the motorcycle since it is very durable.
Accelerant
Don't use not-in-specification fuse wire or other direct lap. Otherwise it will have serious
absence made of circuit system, or even cause fire or burning vehicles, loss of engine power,
it is very dangerous.
Pay attention to the selection rules of the rated current of fuse. Do not use a substitute,
such as aluminium or iron wire, etc. If the fuse wire frequently fuse in a short time, it shows
the electrical system has fault. You should immediately make maintenance unit overhaul.
Catalyst can effectively cut your vehicle exhaust pollutant, the protection and preservation of our
environment; Due to the life of the catalyst is under the precondition of normal use unleaded gasoline
vehicle design, banned the use of leaded gasoline in the love of your motorcycle, because lead can
make a reduction of the catalyst is also very important, if the engine is not effective when the ignition
or without adequate cooling, will cause the exhaust gas gathered in catalytic combustion, catalytic
overheating caused permanent damage to the catalytic conversion ability, banned in any sens long
maintain high engine speed.
Fuse wire
Main fuses, ECM fuses, constant power fuses, hydraulic unit motor fuses, hydraulic unit ECU
fuses, light fuses, spare fuses are located in two main fuse blocks, starter fuses, ABS fuses, auxiliary
fuses, and other fuses are located in the secondary fuse box.
1. The main fuse protects all circuits.
2. ECM fuse protects ECM, ECM relay, oil pump relay and other electrical components
3. Constant power supply protection fan, instrument, anti-theft device connector
4. Hydraulic unit motor fuse protection ABS hydraulic unit motor
5. Hydraulic unit ECU fuse protection hydraulic unit ECU
6. Light fuse protection headlights
7. Start fuse protection start circuit
8.ABS fuse protection ABS controller
9. Auxiliary fuse protection auxiliary parts (position light, turn signal, tail light, brake light, license
plate light, horn, overtaking light)
10. Other fuse protection deputy handle switch (except faucet lock switch), instrument, windshield,
anti-theft device joint)
Headlight beam height adjustment
Manually rotate the dimming handle clockwise (as shown in the figure below) to lower the light,
and turn the dimming handle counterclockwise to increase the light. You can also insert a Phillips
screwdriver into the cross slot in the middle of the dimming handle, and adjust the light level in the
same way as above.
Содержание VX 350
Страница 1: ......
