26
Engine Oil
Whether the engine can be durable, it is very important to select the high quality oil and regular
replacement of new oil. Check the oil level and oil change on a regular basis is two important tasks of
maintenance project.
Check the oil level, according to the following steps to check oil level
.
1. Park the motorcycle on a level surface and keep it upright.
2. Start the engine and run it at idle speed for 3-5 minutes.
3. Turn off the engine and wait 3-5 minutes.
4. Keep the vehicle upright and observe the oil inspection window. The oil level should be
between the minimum and maximum oil level markings.
At each maintenance cycle, we should replace the engine oil. Oil change should be performed
under the condition of the engine, so the old engine oil can discharge more thoroughly. Steps are as
follows:
It is strictly forbidden to start or run the engine during the process of draining the oil. Before
starting the engine, it must be ensured that there is enough oil in the engine.
1. Park the motorcycle on a flat surface with the side frame.
2. Unscrew the oil filler plug counterclockwise.
3. Place an oil drain pan under the engine oil drain bolt.
4. Remove the oil drain bolt with a tool and drain the old oil.
Engine oil replacement
When the engine oil is too much or too little, running the engine can damage the engine. Stop the
motorcycle on the flat ground and check the engine oil level gauge. The oil level must be between the
lowest and the highest lines. When checking the oil level, make sure that the motorcycle is standing
upright and slightly incline to either side may cause the inspection error.
Please replace the oil in the franchised dealer or repair shop. Unauthorized replacement is not
allowed. Please consult the professional staff to ensure correct disassembly when the lower fairing cover is
removed. Please dispose the disused engine oil properly and don’t pollute the environment. We recommend that
you put the disused oil into a sealed container and send it to the local recycling center. Don’t put it in the dustbin
or pour it directly onto the ground.
If you doesn't use the prescriptive engine oil, it might damage the engine.
When the engine is running, it is forbidden to open the oil filler plug to prevent the high temperature oil from
splashing and hurting people.
5.Reinstall the drain bolt and washer. Use a wrench to screw down the drain bolt. (tighteening
torque would be 24
±
4N.m
）
6.Add 1600ml from the engine oil filling hole (if the oil filter element is replaced, add 1700ml), the
viscosity is SAE 5W-40 (ring ambient temperature -20°C~20°C)/10W-50 (ambient temperature above
0°C), "ZONTES" motorcycle four-stroke engine of API SN level or higheroil, and then tighten the oil
filler plug.
7.With different speeds launch machine for 3 minutes. When engine is running, check leakage
situation with dismantling parts.
8.
8.Operate the engine at idle speed for 5 minutes, and then turn off the engine for 3 minutes
,
check oil level through oil foot calibration. If the oil level is lower than the oil inspection port minimum
scale line, you should add new oil to the highest scale line. Once again, check for leaks.
Engine oil drain bolt
Maximum oil level marking
Minimum oil level marking
Содержание VX 350
Страница 1: ......
