22
Storage battery
The battery is located under the driver's seat cushion, please connect the positive and negative
poles and install the battery straps for the first time
.
Disassemble the battery in the following steps:
a. Turn off the motorcycle power switch.
b. Remove the cushion.
c.
L
oosen the battery strap
d.Poke black protective cap, remove the negative extreme ( - ), push aside red protective cap,
remove the positive extreme ( + ).
If you don't drive your motorcycle for a long time, please remove the battery and charge it
per month.
Battery should be checked regularly, if the voltage is lower than 12V, we suggest for
battery charging.
Battery charging will shorten the life of the battery. Don't let the battery over charge.
Please charge the battery when you use the professional lithium battery. The charging
voltage should not be over 15V.
Please properly deal with waste battery and waste electrolyte, don't damage to the
environment.
We suggest that you will recycle waste battery and waste electrolyte to a local recycling
center. Don't discard it in the dustbin or discarded directly on the ground.
If the battery voltage is greater than 12.3V, the meter restarts with a black screen when
igniting, you need to short-circuit the start relay to see if the same situation exists, such as
If the situation is the same, do not ignite for a long time (and each ignition time needs <3S)
or stop the ignition, you need to go to the nearest dealer to check
Whether the vehicle starting mechanism is normal, otherwise there may be a risk of
burning the battery.
Replace the battery, please note the following:
When you replace battery, you shall confirm the battery type and verify the models are consistent
with the original battery. the specification of the battery in motorcycle design is considered as the
relative match. if switch to a different type of battery, it could affect the performance and life of the
motorcycle, and is likely to trigger circuit fault.
When reinstalling the battery after removing the battery, you need to pay attention to
straighten out the surrounding wiring harness, especially the position of the positive pole of
the battery and other red, The wires need to avoid touching metal such as the frame and the
battery box bracket, and the battery needs to be completely inserted into the battery box and
the battery bandage must be tied (installed small cover) to ensure that the positive position of
the battery is within the protection range of the positive protective plate.
When reinstalling the battery, starting or when the whole vehicle has power failure, battery
dormancy restarting, abnormal idle speed, plug and unplug insurance and other similar
situations, please pay attention to reset individual hardware of the electronic injection. Steps:
Turn on the electric door lock switch and the engine ameout switch, start the engine with the
clutch of neutral gear. Turn off the engine ameout switch after 10 seconds and turn on the
engine ameout switch after 10 seconds. Repeat 2 more times.
Please purchase and use our special charger to ensure the extension of the service life of
the battery. There are lead-acid battery chargers for sale in Zontes shop. Users who need them
can go to Zontes shop to purchase the corresponding chargers according to the batteries
equipped with the model
.
It is not allow to use the unqualied charger to charge the original battery.
gel
battery
Содержание VX 350
Страница 1: ......
