Zontes VX 350, Руководство пользователя

Страница: 32 / 50

30
Some chain lubricant containing might damage the sealing ring of solvents and additives, so please use the
special chain oil. If there is no chain oil for the seal chain, you can use high viscosity gear oil SAE90 instead.
Adjustment of transmission chain
Adjust the drive chain sags to the appropriate range. The drive chain adjustment frequency should
accord with the driving conditions.
If drive chain relaxation degree is too big, drive chain sprocket will drop out, and it will be an accident or
severe damage to the engine. Before using the motorcycle, please check and adjust the transmission chain sags.
If drive chain relaxation degree is too big, drive chain sprocket will drop out, and it will be an accident or
severe damage to the engine. Before using the motorcycle, please check and adjust the transmission chain sags.
Transmission chain
The drive chain is made of special raw materials. If you replace the drive chain need to choose the company
integrity part. Use other drive chain may lead to early damage.
Do not use a wire brush to clean the chain.
(Single arm) Follow the steps below to adjust the drive chain:
④
② ③ ①
Step 1: Use the 6# Allen wrench to remove the M8 hexagon socket bolt shown in the picture, then
carefully remove the vice rear fender, taking care not to pull the wire.
Step 2: Loosen the M16×1.5 bolt shown in the picture with a torque wrench of 100N and the outer
hex 21#. Note that it does not need to be completely unscrewed.
Step 3: Use the special chain adjustment tool to clamp the teeth of the eccentric chain adjuster as
shown in the picture, and then turn the eccentric chain adjuster with force (note: Clockwise is loose,
counterclockwise is tight. If you feel too tight to move, then loosen the M16 bolt until you can rotate
the eccentric chain adjuster) and turn the chain adjuster to adjust it to fit the tightness.
Step 4: After adjusting the chain, use the 100N torque wrench and the outer hex 21# to tighten the
loose bolts in step 2.
Step 5: Use the 6# Allen wrench to install the vice rear fender removed in step 1.