27
Engine oil filter
The clutch controller free stroke
Measuring the clutch controller end free stroke, it should be between 10 ~ 15mm. If free stroke is
not correct, accord with the following method to adjust.
Micro adjustment
1.Loose clutch digging line nut
①.
2.Rotate clutch digging line adjustor
②
to get proper free stroke
3.Screw down the clutch digging line nut
①.
Large adjustment
1.Loose clutch digging line nut
④、⑤.
2.Rotate clutch digging line adjustor
③
to get proper free stroke
.
3.Screw down the clutch digging line nut
④⑤.
If the clutch controller free stroke is too large, it is e asy t o c ause c lutch a nd s hift in stitutions w ear a nd failure
Maintain and adjust the clutch should be performed by the designated company service units.
The adjustment and maintenance of the clutch shall be carried out by a dealer authorized by ZONTES.
1.Place the oil unloading tray under the right crankcase cover.
2.Remove 3 cap nuts on the oil filter cover with the special tool. Loosen the oil filter cover by the
rotating softly from left and right, and disassemble the oil filter cover. It is strictly forbidden to pick up
the oil filter cover with a hard object, otherwise it will lead to oil seepage.
3.Disassemble the oil filter cover, and disassemble the old oil filter ,the seal ring of oil filter will be
stuck to the old oil filter.If don't replace the seal ring, please remove it and use again, but must not
forget this seal ring .
4.Wipe off residual oil and impurities with a clean paper towel, check and install the filter spring
and replace a new oil filter.
Please properly recycle and handle the used oil and oil filter.
It is very important to install the oil fine filter correctly, please use the original oil fine filter, please do not
install the oil fine filter in reverse, spring and fine filter
Do not forget to install
the sealing ring. Be sure to double check that the use of a non-original oil fine
filter or incorrect installation may result in contamination or missing oil cause serious damage to the engine.
Before installing the fine filter cover, please carefully check whether the O-ring on the oil
fine filter cover is damaged. When installing the fine filter cover, the O-ring,the phenomenon
of trimming should not occur. If there is damage or trimming, please ask the dealer to replace
it in time, otherwise it will cause oil leakage.
Be sure to install the fine filter cover according to the correct steps, otherwise it will
cause oil leakage.
10
-
15mm
A side
B
side
①
A
side
5.Before re-installing the oil filter cover: If necessary please replace the oil filter seal ring and O-
ring on the oil filter cover, align the filter cover with the screw hole and press it in parallel with the
mounting hole, Hold the fine filter cover by hand and pre-tighten the 3 cap nuts ,the end face (A side)
of the filter cover is attached to the end face (B side) of the mounting hole. Pre-tightening 3 nuts to
make sure that the filter cover can not bounce and then tighten the three cap nuts evenly. The
standard torque is 12 ± 1.5N.m.
Содержание VX 350
Страница 1: ......
