Zontes VX 350, Руководство пользователя

Страница: 18 / 50

16
Avoid operation under fixed low speed
In fixed (light load) under operation at low speed, it will make the parts wear and bad matching. As
long as no more than recommended throttle opening (no more than 3/4 of the opening of the throttle),
it can make the engine speed under various rotational speed. However, during the period of the first
500km, it should not be more than three quarters of the throttle opening.
Let the engine oil cycling
No matter in hot or cold machine status, before starting, you should let the engine had good idle
running time in order to make the oil flow to all lubrication part.
Routine first time examination
The initial 1000 kilometers of maintenance is one of the most important work. During this period,
all engine parts should have good running-in. In the case, maintenance and repair should put all the
parts to readjust, tighten all fasteners, replace parts abrasive dust pollution of the oil. Repair, about
1000 kilometers seriously for the first time, will guarantee your motorcycle to play the best
performance and prolong its service life.
The correct new running-in can prolong the service life of the motorcycle, it can also give full play
to the performance of the new motorcycle. Below is a list of running in right way.
recommended maximum engine speed
Gear and speed of engine
The gear and speed of the engine should be changed from time to time, and do not run
continuously in a certain gear and speed. During the run-in period, the accelerator can be
appropriately increased to make it fully run-in.
Running-in of tires.
Like engine running-in, the adaptation of the new tires need to be correct to ensure the best
performance. In use within the first 150km new tires, we should gradually increase the turning Angle
to connect the ground surface in order to achieve the best performance of the tire. In the use of new
tires within the first 150km, we should avoid nasty acceleration, a sharp turn, and emergency braking.
Running-in of new motorcycle
If the tires are not well run in, it will cause the tires to slip and lose control. After changing
tires, drive with extreme caution. Use the tires correctly according to the contents of this
section, and avoid sharp acceleration, sharp turns and sudden braking during the first 150
kilometers of using the tires.
According to the instruction for use in the inspection and maintenance of an execution
section for 1000 kilometers Maintenance and repair. Please pay special attention to the danger
and warning content of this section.
First 500 kilometers below 5500 RPM
Up to 1500 kilometers below 8250 RPM
Over 1500 kilometers below10000 RPM