Zontes VX 350, Руководство пользователя

Страница: 20 / 50

18
If you are driving this vehicle for the first time, we recommend that you practice on a non-
public road until you are familiar with the controls and handling of the vehicle.
Driving with one hand is dangerous, and should be driven with both hands firmly gripping
the handlebars with both feet on the footrests. In any case, do not drive with your hands off
the handlebars.
Reduce speed to a safe speed before turning.
The road surface is wet and smooth, the tire friction is small, and the braking ability and
cornering ability are naturally reduced, so it is necessary to decelerate in advance.
Crosswinds are usually most likely to occur at tunnel exits, valleys, or when large vehicles
are overtaking from behind, so you must be careful and slow down.
Obey traffic rules and speed limits.
Starting of the engine
When you start the system without key, all the motorcycle will be connected automatically. Check
whether the engine turn off switch is in the position of . At this moment your motorcycle is in the
neutral position, the neutral light will light up on the dashboard.
This motorcycle equipped with ignition circuit and the starter circuit interlock switch. Only
under the condition of the following the engine will start:
1.Transmission is under neutral gear, hold the clutch handle.
2.Transmission is not under neutral gear, side stand is packed up and you hold the clutch
Dumping of sensor when the motorcycle is overturned, will cut off the power and stop the
oil supply, and make the motorcycle stall, and fault indicator will light up. Motorcycle starting
again, you need to turn off the ignition switch, after waiting for 1 minute, reopen the ignition
switch, and starting the engine.
Driving essentials
When the engine is in hot machine status
1.Pack up the side stand.
2.Throttle control handle is on idling position.
3. First pinch the clutch and then press the electric start button to start.
When the engine is in hot machine status and hard to start
1.Pack up the side stand.
2.Turn
the throttle 1
/
8th opening
,
and at the same time pinch the clutch before pressing
the electric start button to start
.
3.When after several times that the engine is hard to start, it is most likely that the cylinder
submerged. In that case, you have to do the clear cylinder process: open the acceleration entirely,
press the starting button for 3 seconds.
When the engine is in cool machine status and hard to start:
1.Pack up the side stand.
2.Turn the throttle 1 / 8th opening, and at the same time pinch the clutch before pressing the
electric start button to start.
3.After starting the engine, keep the engine turning to fully preheated.
The colder is the weather, the longer time the engine needs to preheat. After fully preheat,
you can reduce the engine wear and tear.
When the engine is in cold machine status:
1.Pack up the side stand.
2.Throttle control handle is on idling position.
3.First pinch the clutch and then press the electric start button to start
.
4.When after several times that the engine is hard to start, it is most likely that the cylinder
submerged. In the case, you have to do the clear cylinder process: open the acceleration entirely,
press the starting button for 3 seconds.
When starting the hang gear in neutral, throttle back to bottom, form a habit of holding the
clutch handle before starting. Avoid-error, when it is starting, moving forward immediately.
whether the gear is in neutral or not, you need to squeeze the clutch handle first, otherwise
it will not start, and do n't forget to put away the side stand.
Do not start motorcycle without fuel and engine oil.