Zontes VX 350, Руководство пользователя

Страница: 15 / 50

13
Single arm/double arm(upgrades)
Left/Right handle control system
14.Throttle control handle
Throttle control handle is used to control the engine rotating speed. When turn towards to the
user's side is acceleration; On the other hand, turn towards to the opposite user's side is reduction.
15.Electrical starting button
Press this button to turn on the start-up circuit. When starting, you must set the gear position to
the neutral position, confirm that the engine flame-off switch is in position, and hold the clutch
handle to ensure safety.
W hen c ontinue starting the engine, consecutive start time not more than five seconds at a time. Because a
large number of start can make some abnormal heating to circuit and start motor. If you still can't start it a few
time, you should stop and check the oil supply system and start the circuit system. (please refer to
"troubleshooting" section.)
16. Light switch
Position: When
the engine is working
,
the left and right hand switches backlight
,
front light,
front position light, rear position light, and nameplate light are all on together.
Position: front position light, rear position light and nameplate light are all on together.
17. Red power-on button
When the host is in the sleeping version, press the "START" button in short time to wake up the
host. After detecting the response signal of the key and the signal of the handle bar lock, the whole
vehicle will START up. Press the "START" button in long time, the host will enter into sleep version,
and the whole vehicle will be shut down.
For details of the operation of MOD button and SET button, please refer to the main menu of the
meter.
18. Seat cushion lock switch
When the engine is not starting with the seat cushion locking, press the SEAT switch to open the
seat cushion lock.
If the seat is not installed into position, the seat will glide which and will lead to the driver to lose control of the
motorcycle. Make sure the seat cushion is locked in the correct position.
Front pedal installation
1. Adjust the position of the front left pedal
Tools: No. 8 open-ended wrench, No. 10 open-ended wrench, No. 14 Torx wrench
1. Use a wrench to unscrew the M6×30 bolt
①
;
2. Remove the front fender bushing
③
from the adjusting screw to shorten the adjusting screw;
3. Remove the support mounting bolts M10×25
②
, install the pedal support on the rear hole, re-
tighten the M10×25 bolts, and tighten them.
2. Adjust the position of the front right pedal
Tools: No. 14 open-ended wrench, No. 10 open-ended wrench, No. 14 Torx wrench
1. Remove the cotter pin and pin
④
, and use the No. 10 and No. 14 open-end wrench to unscrew
the extension rod
②
and U-shaped joint
③
;
2. Connect the U-shaped joint directly to the rear brake main pump
①
;
3. Remove the support mounting bolts M10×25
⑤
, install the pedal support on the rear hole, re-
tighten the M10×25 bolts, and tighten them.
Front pedal installation
①
③
① ② ③
⑤
②
④
The front pedal is installed in the frontmost position before leaving the factory, and the
user can adjust it to the latter installation position by himself.