Zontes VX 350, Руководство пользователя

Страница: 35 / 50

33
Braking system
Front wheel
Check the front brake disc: see if the thickness of the brake disc is less than 4.5 mm. If the
thickness is less than 4.5 mm, the brake disc should be replaced.
Replacing only one of a pair of brake pads will result in uneven braking. Replace a pair of brake pads at the
same time.
If the location of the brake piece is wrong, please do not operate the brake handle or the brake pedal. If you
operate on brake lever or the brake pedal, piston is hard to reset, and it can lead to the brake fluid leakage.
Rear wheel
Check the rear brake disc: see if the thickness of the brake disc is less than 4.mm. If the thickness
is less than 4.0 mm, the brake disc should be replaced.
If the adjustment is not correct, brake piece and brake disc will be forced all the time which can damage the
brake and the brake disc, when it is severe it will lead to high temperature for the rear brake, produce gas
resistance, the rear wheels lose braking force. Please adjusted brake pedal according to the content of this
section correctly.
Brake disc
Adjustment of rear brake pedal
If it is not replaced when the service life is reached, please contact the authorized dealer of
zontes for repair.
If driving after the maintenance of the brake system or replace the motorcycle brake,
operate only a few with the brake lever or brake pedal, braking effect will be worse, and the
accident will happen. Maintenance of the brake system or replace the brake after operating
brake handle, or the brake pedal several times, until the brake disc can be normal pressure
brake disc, brake lever and brake pedal back to normal hydraulic resistance.
When you have just replaced a new brake disc pad, do not drive immediately. Grab the brake handle several
times or pedal the brake pedal several times to make the brake disc and the brake pad fit together to restore the
normal grip and stabilize the brake fluid circulation.
After replacing the new brake disc or brake pad, the braking distance may be longer than the original braking
distance. After 300 km or so, the brake disc and the brake disc can be fully meshed to achieve better. Braking
effect, before this, pay attention to leave enough braking distance when driving.
85mm
1.Loosen the lock nut
①
, the rotation of the screw
②
, the brake pedal position at the top of the
foot below 85 mm.
2.Lock nut
①
to ensure that the screw
②
in the right place
The rear brake pedal position shall be maintained properly. Or braking and brake disc will always
friction which will damage the brake and the brake disc. Adjust the position of the brake pedal
According to the following method.