5
PKE
user
manual
PKE (Passive Keyless Entry) system user manual:
The PKE system consists of a PKE accessory (Figure 1), a PKE host (Figure 2), a key (Figure 3),
a non-electric induction antenna (Figure 4) and a low-frequency transmitter antenna the line (Figure
5) consists of five parts.
PKE
host (Figure 1) function description:
①
Battery charging DC port
②
Charging fuse
③
PKE fuse
1. Use of the sensor key
The motorcycle is equipped with two sensor keys, one of which should be kept for future use.
The two induction keys are marked with numbers, which correspond to the numbers of the PKE
host. The PKE host can automatically identify an induction key corresponding to the approaching
vehicle without activation
2.PKE power up:
When the PKE is connected to the power supply for the first time (such as connecting to the
battery power supply or plugging in the PKE fuse), when the key is not within the sensing range of
the vehicle, the vehicle will beep 4 times, representing
1) PKE normal reset work prompt.
2) Press the power button to prompt (similar to pressing the START button), if the key is detected,
it will turn on, otherwise it will immediately switch to the non-electric induction mode to turn on.
3) Press the power button for a long time, and the no-electric induction mode is activated.
4) Inductive shutdown prompt in non-eletrict induction mode.
If the main lock is not unlocked successfully, it may be that the handle is pinned to the faucet lock locking
shaft, turn the handle lightly to let the lock move freely, or the battery power is too low to unlock the lock, please
check whether the battery power is normal.
After checking that the battery power is normal, short press the red power-on button, the motorcycle cannot
be turned on, but the main unit will emit a "di" prompt, please check the battery power of the key and try to use
the wireless induction start mode (for details, see the follow-up instructions) If the battery power is normal and the
host does not emit a beep sound, please check whether the PKE fuse (picture 1) is normal, and replace the fuse
with the same specification fuse (15A)
When the battery is dead, please try to turn it on after charging is complete and unplug the charger.
3.Turn on the PKE:
Short press the START button on the right auxiliary handle (Figure 6), the turn signal flashes
twice, the faucet lock is automatically unlocked, and then the buzzer "di" prompts once, and the
circuit is connected.
The detection time of non-electric induction is between the third and fourth sound, and the
detection time is 5 seconds.
3
4
5
1
2
6
3D antenna
sensing area
Fuel tank
lock button
Seat lock button
S T A R T button
There are two green and red LEDs on the sensor key. When the battery of the sensor key is sufficient, it will flash
green light every 3 seconds or so when the host is turned on. When the battery is low, the red light will flash.
(When the key battery is just installed, the key light will flash once, you can judge whether the key battery status is
based on the key light) Due to the limited capacity of the key battery, the normal battery life is about 6 months. If
your sensor key is not sensitive or the sensor key indicator flashes red, please consider replacing the battery.
(There is a pry opening on the back cover of the induction key, which can be replaced by prying open, and the
battery is a 1225 button battery)
Содержание VX 350
Страница 1: ......
