ZF CruiseCommand 785CE, Инструкция по установке и устранению неисправностей

Страница: 63 / 160

ADJUSTMENTS AND TESTS UNDERWAY
Page 55
G)Position the Control Head lever to the Ahead Detent and turn
Troll Mode On. (Depress transfer button for approximately 2
seconds, or until the red LED on the Control Head begins
blinking at a fast rate.)
H)Depress either the Up or Down Arrow on the Processor to acti-
vate the Function Menu.
J) Activate Set-up Mode. Refer to Section 6.2.
K)Change the Value of the Function.
L) Record Propeller Shaft RPM on Table 7:
E)Attach the Multi
Meter Black
(COM) and Red
(mA) Leads as
shown in Figure
55:
F) Turn ON power to
the Clutch Power
Supply. Ensure
Power is On to the
Processor.
Figure 55: Multi Meter and Test Unit Connections
Figure 56: L2 - Troll Minimum Set-up
Activated
I) Use the Up or Down arrow to scroll to the L2
Troll Minimum Pressure Function Code.
Refer to Figure 56:
• The Multi Meter will read the output signal
for Troll Minimum when the Troll Com-
mand Switch on the Test Unit is flipped
towards "Troll Command".
NOTE: When the trolling valve is in the minimum oil pressure position, Propeller Shaft RPM
should be 30% of the engaged RPM noted in Table 6:.