ZF CruiseCommand 785CE, Инструкция по установке и устранению неисправностей

Страница: 123 / 160

TROUBLESHOOTING TRAIN-156 Rev.B 11/01
Page 27
In addition to the Error Codes listed above, some problems may not
necessarily generate Error Codes. The following give some examples
where isolating the cause of a problem may not be as easy as reading
off an Error Code.
Err
#
Cause Solution
48 a) The Serial Harness is not connected to ID #5 although it has
been selected.
b) If (5) items had been selected, ID #5 has not been identified.
c) Loss of power to ID #5.
a) Connect the Serial Harness into ID #5.
b) Identify one item as ID #5 with the “A0” function.
c) Restore Power to ID #5.
49 a) The Serial Harness is not connected to ID #6 although it has
been selected.
b) If (6) items had been selected, ID #6 has not been identified.
c) Loss of power to ID # 6.
a) Connect the Serial Harness into ID #6.
b) Identify one item as ID #6 with the “A0” function.
c) Restore Power to ID #6.
50 a) The Serial Harness is not connected to ID #7 although it has
been selected.
b) If (7) items had been selected, ID #7 has not been identified.
c) Loss of power to ID # 7.
a) Connect the Serial Harness into ID #7.
b) Identify one item as ID #7 with the “A0” function.
c) Restore Power to ID #7.
51 a) The Serial Harness is not connected to item ID #8 has been
selected.
b) If (8) items had been selected, ID #8 has not been identified.
c) Loss of power to ID # 8.
a) Connect the Serial Harness into ID #8.
b) Identify one item as ID #8 with the “A0” function.
c) Restore Power to item ID #8.
52 a) The Serial Harness is not connected to item ID #9 has been
selected.
b) If (9) items had been selected, ID #9 has not been identified.
c) Loss of power to item ID #9.
a) Connect the Serial Harness into ID #9.
b) Identify one item as ID #9 with the “A0” function.
c) Restore Power to item ID #9.
53 a) The Serial Harness is not connected to item ID #10 has been
selected.
b) If (10) items had been selected, ID #10 has not been identi-
fied.
c) Loss of power to item ID #10.
a) Connect the Serial Harness into ID #10.
b) Identify one item as ID #10 with the “A0” function.
c) Restore Power to item ID #10.
54 a) The battery is being over-charged.
b) There’s a high resistance connection at the battery while
being charged.
a) Repair or replace the charging system.
b) Clean and or tighten the connections at the battery.
55 a) Defective battery.
b) The battery is not being properly charged.
c) There’s a high resistance connection between the Processor
and it’s power source.
a) Replace the battery.
b) Repair or replace the charging system.
c) Repair the high resistance connection as needed.
56 An unexpected software or hardware reset has occurred. Replace the Processor.
57 An unexpected software reset has occurred. Replace the Processor.
58 An unexpected software or hardware reset has occurred. Replace the Processor.
Table 2: Problem Scenarios