ZF CruiseCommand 785CE, Инструкция по установке и устранению неисправностей

Страница: 64 / 160

ADJUSTMENTS AND TESTS UNDERWAY
Page 56
M)When the value required is displayed, store the value. Refer to
Section 6.2.
N)Position the Control Head lever through the selected Troll
Lever Range to the Troll Maximum position.
P) Activate Set-up Mode. Refer to Section 6.2.
Q)Change the Value of the Function.
R) Record Propeller Shaft RPM on Table 8:
Table 7: Minimum Trolling Pressure
SINGLE SCREW
Propeller Shaft RPM at minimum trolling pressure
Approx. 30 - 50% of Table 6:
Shaft RPM Current (mA) Function %
TWIN SCREW
Propeller Shaft RPM at minimum trolling pressure
Approx. 30 - 50% of Table 6:
Shaft RPM Current (mA) Function %
PORT
STBD
Figure 57: L3 - Troll Maximum Set-up
Activated
O)Use the Up or Down arrow to scroll to the L3
Troll Maximum Pressure Function Code.
Refer to Figure 57:
• The Multi Meter will read the output signal
for Troll Maximum when the Troll Com-
mand Switch on the Test Unit is flipped
towards "Troll Command".
NOTE: It is difficult to use a slipping clutch to control shaft RPM between 70 percent and 100 per-
cent of normal shaft RPM. However, it may be desirable to set the Maximum Trolling
Pressure position higher than the 70 percent RPM, so that added oil pressure is available
when maneuvering.