User’s Manual 1PH HYD3000-HYD6000-ZP1
Rev. 1.0 01/09/2023
Identification: MD-AL-GI-00
Rev. 1.1 of 27/01/2023 - Application: GID
189/193
Enter the serial number (S/N) of the datalogger and click “Check RMS”. If the datalogger has been configured
correctly, a screen will open where you can enter the required information relating to the field to be installed.
Once the “location” of the field has been entered, click “Calculate Location Information” to allow the system to
obtain the latitude, longitude and time zone of the installation. Click “Confirm” to complete the configuration
of the field. You only need to wait a few minutes to view the data flow on the ZCS Azzurro portal.
ATTENTION:
The location data is essential for the correct operation of the datalogger in the ZCS system.
It is important to define it very carefully.
15.6.8.
Network configuration
At the time of purchase, the Datalogger is configured in DHCP, i.e. dynamic configuration.
However, if you want to set up a static configuration for your Datalogger, you can access the internet page via
the link RMSxxxxxxxx: 8888, as shown in the figure (e.g. RMS00000007).
By entering the credentials: username = admin and password = admin, you can change the configuration from
dynamic to static by selecting the network window (see
blue arrow
) and then the “STATIC” option (see
green
arrow
).