YASKAWA SGD7S-xxxDA0 series, Руководство по эксплуатации продукта

Страница: 236 / 636

7.9 Absolute Linear Encoders
7.9.3 Output Ports for the Position Data from the Absolute Linear Encoder
7-41
7
Application Functions
7.9.3 Output Ports for the Position Data from the Absolute
Linear Encoder
You can read the position data of the absolute linear encoder from the PAO, PBO, and PCO (Encoder
Divided Pulse Output) signals.
The output method and timing for the position data of the absolute linear encoder are different in each
case.
A conceptual diagram of the connections of the PAO, PBO, and PCO (Encoder Divided Pulse Output)
ports to the host controller is provided below.
The PAO (Encoder Divided Pulse Output) signal outputs the position data from the absolute linear
encoder after the control power supply is turned ON.
The position data of the absolute linear encoder is the current stop position. The absolute linear
encoder outputs the upper 16-bit data (with sign) according to the specified protocol. The absolute
encoder outputs the lower 20-bit data as a pulse train. It then outputs pulses as an incremental linear
encoder (incremental operation status).
The host controller must have a reception circuit (e.g., UART) for the position data from the absolute
linear encoder. The pulse counter at the host controller will not count pulses when the upper 16-bit
data (with sign) (communications message) is input because only phase A is input.
The output circuits for the PAO, PBO, and PCO signals use line drivers. Refer to the following section
for details on line drivers.
4.5.4 I/O Circuits on page 4-33
Signal Status
Signal Contents
When Using an Absolute Linear Encoder
PAO
First signal
Upper 16-bit data (with sign)
Lower 20-bit data (pulse train)
During normal operation Incremental pulses
PBO
First signal Lower 20-bit data (pulse train)
During normal operation Incremental pulses
PCO Always Origin pulse
Serial
data
ENC
CN1
Host controller SERVOPACK
PAO
PBO
PCO
CN2
Conversion of
serial data to
pulses
Dividing
circuit
(Pn281)