Xerox DocuPrint 4635, Руководство оператора

Страница: 123 / 344

JOB CONTROL TASKS
MICR control
The 4635MX LPS may run in MICR or non-MICR mode. This
gives you control of the printer MICR state. Refer to the chapter
“MICR operating procedures“ for information on how to perform
the mode selection.
Bar code reader control
Refer to the chapter “Bar code operating procedures“ for
information on the bar code reader related operations.
Fonts/forms/graphics
In order to improve printer throughput, you can define the
maximum number of fonts, forms, and graphics that the system
stores in memory during a print job. The values remain in effect
until you change them or perform an LPS Update or Sysgen task.
(Refer to the 4850 HighLight Color and 4635 LPS System
Generation Guide for additional information.)
Use the Fonts/Forms/Graphics task to set the maximum number
for the following:
• Fonts. Sets the maximum number of active fonts per print
job. No single printed page can have more fonts than this
number.
Note: This number must include all fonts used on the form
as well as in the variable data.
If the number of fonts specified is exceeded during a print
job, the job aborts and a message displays in a message
window on the PC UI or the display screen of the system
controller.
• Forms. Sets the maximum number of active forms per print
job. Specifying a number larger than one allows form
changes on a page to page basis without negative effects on
printing speed as long as there is room for all the forms in
system memory.
• Graphics. Sets the maximum number of active graphics per
print job. No single printed page may call for more than 16
graphics.
Note: This number must also include all graphics used on a
form for the page, if a form is used.
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE 5-11