Xerox DocuPrint 4635, Руководство оператора

Страница: 118 / 344

JOB CONTROL TASKS
• '+' is the direction the image moves if you increase the
number in the field.
2. To change the alignment, enter a new value in the Lines and
/or Dots field(s).
3. Select the appropriate header button:
• Apply/Close. Apply your selection and close the window.
• Apply. Apply your selection.
• Close. Close the window.
• Test. Print a sample with the new alignment applied. If a
job is currently printing, a page from the job with the
new alignment applied is delivered to the sample tray. If
a print job is not running, the test form is delivered to
the sample tray. (Refer to figure 5-5.)
• Redisplay. Return the alignment to the values displayed
when you first opened the Align window.
Align task through command line To change the alignment for forms:
1. Enter ALIGN to display the current setting (normal operating
setting). For example:
OS1380 ALIGNMENT IS 1 SCAN LINES AND 0 DOTS
2. To change these values (and move the image to correspond
to your form), key in ALIGN plus the new line value and the
new dot value. There is a space between ALIGN and the
number for the new line value, but only a comma between
the values for the lines and dots. For example, if the initial
alignment was 1 and 0, ALIGN 16,20 changes the initial
alignment by 15 lines and 20 dots.
When using the test pattern, which is in landscape format,
adding dots moves the image to the right; adding scan lines
moves the image toward the bottom of the page. You may
move the image by adding as many as 296 lines and up to
1496 dots. To go in the opposite direction, subtract dots or
lines. You may not use negative numbers.
3. To check the amount of shift, key in SAMPLE TEST.FRM to
print the built-in test form (refer to figure 5-5), or you may
print a sample of the actual job on the preprinted form to be
used.
5-6 XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE