Wintriss SmartPAC PRO, Руководство пользователя

Страница: 67 / 318

SmartPAC PRO User Manual 1143100
Chapter 2 – Installing SmartPAC PRO 67
To mount the ProCamPAC Output Assembly and wire it to the ProCamPAC board inside the
SmartPAC PRO control, follow the instructions below. These instructions may be used with either the
8- or 16-channel ProCamPAC board. Refer to Table 2-8 and Table 2-9 for wiring connections. A
wiring diagram is provided in Figure 3 at the end of the manual.
1. Select a convenient location for running conduit from the ProCamPAC Output Assembly to the
equipment that it will control.
2. Mount the output enclosure, using the mounting holes on the flanges as shown in Figure 2-14.
3. Select the relays to be used with each channel. Relays should already be plugged into the Cam
Outputs board (see Figure 2-14), each relay labelled with its type (i.e., standard or solid state).
Standard relays can be plugged only into the slots labeled K301 through K305, K307, K309, and
K311, which are channels 1-8. Optional solid state relays can be plugged only into slots labeled
K306, K308, K310, and K312, which are channels 5-8.
Locate the 12-conductor cable(s) for wiring the ProCamPAC board solid state relay into
channel 5 (location K306), you cannot plug a standard relay into location K305. See Figure 2-14.
Example
Say you wish to use three standard relays and one solid state relay. You would install the
three standard relays in channels 1 through 3, and the solid state relay in channel 5,
skipping the channel 4 output for all wiring and programming.
4. To remove a relay, pull the plastic retention clip away from the relay and pull the relay straight
out of its socket. When re-inserting the relay, make sure that the pins line up with the socket
holes, then press in firmly.
5.
Locate the 12-conductor cable(s) for wiring the ProCamPAC board (see Figure 2-14 for layouts
of 8- and 16-channel boards) to terminal block TB301 inside the ProCamPAC Output enclosure.
If you are wiring an 8-channel ProCamPAC, one cable is supplied (for channels 1-8). If you are
wiring a 16-channel board, two cables are supplied, one for channels 1 through 8, the other for
channels 9 through 16.