Lync AEGIS Controller
7: APPENDIX C - ACCESS TO THE WEB SERVER
L-OMM-013_A
• 4/20/2022Technical Support • (800) 433-5654 • Mon-Fri, 8 am - 5 pm EST
57
of
100
7. APPENDIX C - ACCESS TO THE WEB SERVER
If not otherwise indicated on the controller, the standard IP address is 192.168.1.150.
The controller’s IP address can be found on the ET sub-menu of the service menu. To connect to
the website, the controller has to be connected to a LAN
– local area network.
7.1. Ethernet Connection
7.1.3. Ethernet Port
The unit controller provides a single ethernet port, located on the upper side of the controller, as
shown below. Please note that the ethernet port can be factory wired to an UMTS router
(dedicated to remote maintenance) or to a multiport switch. An additional RJ45 socket to bring the
Ethernet connection outside the unit is available, providing the option to connect to the controller
without the need to open the door of the electrical panel. Please be aware that the declared
socket IP67 degree protection is ensured only when the protection cap is fastened. This external
socket is mainly intended for maintenance. If it is used for permanent network connections, make
sure that the installation environment is protected from water and dust.
Controller Ethernet port
