28
20306743
KSTDV Series Gas Fireplace
FINAL INSTALLATION
ROCK WOOL PLACEMENT
Place rock wool evenly in dime-sized pieces over front and
rear burner both in front and behind rear grate. For the
middle burner, place the rock wool only on the carry-over
areas between the
fl
ames. To better enable the gas to
permeate the rock wool, apply the rock wool in light,
fl
uffy
pieces.
WA
R
N
IN
G
Do not use the entire bag of rock wool to
cover the burner. This could cause the fl ame
to burn poorly and may lead to sooting.
Figure 37 -
Rockwool placement
Wall Brick
Floor Brick
Hearth Brick
Light Box Cover
Figure 36 -
Install Brick
LIGHT & BRICK INSTALLATION
1. Remove glass frames from
fi
replace.
2. Remove the six (6) screws securing each light box and
remove from unit.
Figure 34
Figure 34 -
Remove Light Box Cover
Bulb Socket
Light Bulb
Light Box
Cover
Brick Retainer Tab
Lens
Lens Retainer
Bracket
Light Box Cover
Figure 35 -
Remove Lens Retainer Bracket
3. The light bulbs are included in the Homeowner's Manual
packet. Install the light bulbs into bulb sockets as shown
in
Figure 34
.
CAUTION:
Finger prints or the transfer of
oil from hands will reduce the lifespan of the bulbs. It is
advisable to handle the light bulbs with a clean cloth.
4. The light lenses are included in the Homeowner's
Manual packet. Remove the lens retainer brackets and
install the light lenses into the light box covers as shown
in
Figure 35
.
NOTE:
The brick kit will be installed before reinstalling the
light box cover.
5. Install the four (4) hearth brick pieces on each side of
the unit, in front of the front burners.
6. Place the floor brick panels on the brick supports
between the hearth bricks.
7. Place the wall brick panels against the
fi
rebox walls,
setting on the
fl
oor and hearth bricks. The wall brick will
be held in place by the brick retainer tab on the light box
cover.
Figures 34 & 36
8. The brick retainer tab can be bent to a different angle
to hold the wall brick panels in place more
fi
rmly if nec-
essary.
