Battery
Door
Tabs
Figure 49
20306743
37
KSTDV Series Gas Fireplace
TOUCH SCREEN REMOTE CONTROL OPERATION
NOTE
Due to the sensitive temperature monitoring
components in the transmitter, it is necessary
to allow the transmitter to stabilize to room
temperature before accurate room tempera-
tures are displayed. If the transmitter is acti-
vated from a severe cold condition, allow 15
minutes for accurate temperature readings to
appear on the LCD display.
W
ARNING
Turn appliance OFF (at the Master Switch) if
you are away from your house for an extended
period of time. Never leave anything on top of
the surface of the transmitter.
Information
Bar
Touch Area
Logo
Bar
Menus
Adjustment
Controls
Function Areas of the LCD Display
Figure 48
Logo Bar
The Logo Bar contains the brand logo: Signature Com-
mand System.
Initialization and Setting up
Installing Batteries:
Figure 49
The remote transmitter has two bat-
tery compartments, one on each
end of the transmitter.
Always
change all four (4) batteries at the
same time.
To install batteries:
1. Press down the battery door tab
and pull out to remove the bat-
tery door.
2. Install the batteries as indicated
inside the battery compartments.
3. Close the battery door by snap-
ping in place.
4. When all
four
batteries are installed, the transmitter
will initialize for 5 seconds and then is ready for use.
5. The batteries should be replaced every 12 months or
when the low battery icon indicator is displayed.
Changing Temperature Unit
When batteries are installed in the transmitter,
1. All available icons on the LCD will be turned on then
be cleared.
2. The LCD will display temperature unit: °F. Use ON
∆
to toggle the units between °F and °C within the
fi
rst 5
seconds.
3. The transmitter enters Manual Mode
4. The LCD displays room temperature with the chosen
unit.
Function Areas of the LCD Display
Figure 46 shows the display of the TSFRSC LCD.
Information Bar
The information bar shows the room temperature, the
“sending signal” radio icon, the low battery indication icon,
the child-proof icon, and the
fl
ame icon. This area doesn’t
have touch buttons.
•
The room temperature will always be shown after
power-up. It displays the room temperature from 40
°F to 99 °F. “Lo” and “HI” will be displayed when the
room temperature is lower than 40°F or higher than
99°F, respectively.
•
The radio icon will be shown when the transmitter is
sending a signal.
•
The low battery indication icon will be shown when
the battery voltage is low.
•
The child-proof icon will be shown when the child-
proof mode is activated.
•
The
fl
ame icon indicates the current
fl
ame height -
Off, Low, Medium and High
Touch Area
The touch area contains all touch buttons to control the
transmitter. It consists of two categories: menus and ad-
justment arrows. The blue LED backlight lights up for 8
seconds when any of the touch buttons is pressed.
•
The menus include TIMER, THERMO, LIGHT, FAN
and AUX (Rear Burner Control).
•
The adjustment arrows include ON/up and OFF/
down. Their default function is to adjust the
fl
ame
height. When a button from the menu is pressed,
the ON/up and OFF/down buttons will temporarily
become adjustment controls for the selected item.
When the adjustment is done, the ON/up and OFF/
down buttons go back to
fl
ame height controller
again.
