Unox BakerTop XBC 1005, Инструкция по эксплуатации

Страница: 43 / 338

English
BakerTop
™
ChefTop
™
Before connecting the oven to the electricity mains, compare the power supply data with the appliance
requirements specified on its rating plate.
If the voltages and power supply phases are different, adjust and correct the phase wiring, in accordance
with the data provided on the attached leaflets. Make sure no electricity is dispersed between the phases and
earth. Make sure there is electrical continuity between the outer casing and the electricity mains earth wire.
We recommend the use of a digital multimeter when performing these procedures.
Caution!
Make sure all electrical connections are secure before connecting the appliance to the electricity mains.
1. Ovens fitted with Schuko plug and cable (single phase): simply insert the plug into the relevant socket (the
socket should be suitable for use with the plug supplied);
2. Ovens fitted with a (three-phase) cable attached to the terminal board in the figure: these ovens are supplied
with a 5-wire electricity cable and leave the factory having been set up for three-phase connection with neutral;
the cable should be connected directly to a switchboard. Means for disconnection must be incorporated in the
fixed wiring in accordance with the wiring rules.We recommed the use of a safety switch for fault currents.
During appliance operation, the power supply voltage should not deviate from the nominal voltage value specified
on the appliance rating plate.
To carry out other types of connection, please refer to the "Technical data" attachment to check the connection
methods used for the oven model in question, as well as the type of cable that should be used.
Connection diagrams can be found on the inside of the terminal board cover.
Only perform the connections indicated on the technical data sheet, fitting the copper jumper and electricity cable
underneath the screw in its tightening direction, so that when the screw is tightened, the cable and jumper are
tightly secured.
3. Ovens fitted with a three-phase terminal board on a DIN bar: to connect the oven electrically, please refer to
the "Technical data" attachment in order to check the connection methods used for the oven model in question,
as well as the type of cable that should be used; for teminal board connection, open the lower part of the oven
back panel and run the power supply cable through the relevant cable clamp.
Only perform the connections indicated on the technical data sheet.
The appliance should be connected directly to a switchboard. Means for disconnection must be incorporated in
the fixed wiring in accordance with the wiring rules. We recommed the use of a safety switch for fault currents.
During appliance operation, the power supply voltage should not deviate from the nominal voltage value specified
on the appliance rating plate.
1. 2. 3.
43
Electrical connections