115
Appendix F: Wiring Diagrams
HS2016, HS2032, HS2064, HS2128 UL/ULC Wiring Diagram
Compatible
System Keypads
Bell/Siren
700mA (max)
Observe Polarity.
120V
AC
/60Hz
Primary
16.5V
AC
/40VA
NOTE:
Battery capacity for 4h standby is at least
4Ah. (Max. Aux current must not exceed 700mA).
Battery capacity for 24h standby is 14Ah (Max.
Aux current must not exceed 470mA). Recommended
Batteries: DSC BD4-12 or DSC BD7-12.
12V 4.0Ah/7Ah
12V 7Ah
RJ-31X Telephone
Plug 26 AWG
Maximum battery
charge current
is 400mA
AUX+
PGM2
2k2
EOLR
Normally Open
Push-button Switch
RESISTOR
ID
2-WIRE SMOKE
BELL CIRCUIT
SINGLE ZONE EOL
NOTE:
Refer to Installation Manual & Smoke
Detector Instruction Sheet when locating detectors.
35mA
max.
Class 2 Transformer
Model DSC PTD1640U
SIA-FAR Minimum System Requirements:
1 HS2016/2032/2064/2128 Panel
2 Local annunciation devices
Local annunciation devices may be
any combination of these keypads:
HS2LCD, HS2LCDP, HS2ICN, HS2ICNP, HS2LED
220
POWER LIMITED
POWER LIMITED
DO NOT
combine different models on the same circuit
as operation may be impaired.
Ground wire from
building electrical
installation
IMPORTANT: Minimum
6.4mm (1/4”)
separation must be
Temperature Range: 0°C-49°C [32°F-120°F] / Maximum Humidity:
93% R.H.
The HS2016/2032/2064/2128 is UL Listed for limited energy
installations per NEC Article 760. Recognized limited energy cable
should be used. Observe NEC wiring requirements and local
codes defined by the authority having jurisdiction. Security
detection devices that require power from the control panel must
be UL Listed for the intended application and operate over the
range of 11.6-12.6VDC (residential), 12.0VDC (commercial).
PG9904(P), PG9934(P), and PG9974(P) are recommended UL
Listed motion detectors. Compatible system keypads:
HS2LCDRF(4)(8)(9), HS2LCDRFP(4)(8)(9), HS2ICNRF(4)(8)(9),
HS2ICNRFP(4)(8)(9), HS2LCD, HS2LCDP, HS2ICN, HS2ICNP, HS2LED
This device complies with Parts 15 and 68 of the FCC rules. Operation is
subject to the following 2 conditions: [1] this device may not cause harmful
interference and [2] this device must accept any interference received,
including interference that may cause undesired operation.
Model: HS2128 FCC Reg. No. F53AL01BPHS2128
REN = 0.1B Plug Type: RJ-31X MADE IN CANADA
ULC NOTES
•
For ULC Listed Fire Monitoring Installations & module
requirements, please refer to the ULC Installation
Information Sheet, part #29002157.
• Use a CSA/cUL transformer, hardwired.
• All tamper circuits may be connected to the same
zone.
• Use ULC-LA for AC Power indication.
(a) The delay (power-up) time marked on the installation wiring diagram of the smoke detector or on the installed
smoke detector(s) is to be used.
*AUX Wiring
Use No.14-22 AWG conductor
AUX+ and Keybus (RED) are internally
connected. Total current draw from
keypads, PGM Outputs and AUX circuits
must not exceed 700mA.
NOTE:
Do not connect
transformer to a
receptacle controlled
by a switch.
FSA-210B Series
NOTE:
Refer to the FSA-210 Installation Manual for more details.
Maximum Number of Detectors: 18
HS2016/2032/2064/2128 UL/ULC Wiring Diagram
NAME
MODEL
MAX #
BASE
COMPATABILITY ID
DSC
NONE
FS200
SEE NOTE
Control panel is suitable for the following UL installations: (1)
Grade AA Central Station and Grade AA Police
Connect with high line security (using T-LINK to communicate to the Sur-Gard MLR-IP Receiver). (2) Household Fire
and Grade A Household Burglary and Home Health Care Signaling Equipment (3) Grade A Local I Grade B Central
Station and Police Connect with basic line security (4) Grade C Central Station. Refer to Installation Manual
ULC-LA
HS2016-4
HS2064
HS2128
Only
HS2016-4
HS2032
HS2064
HS2128
2-WIRE SMOKE DETECTORS
PGM CONNECTIONS
700mA*
(see Aux
note above)
CORBUS
AUX INPUT
WIRING
4-WIRE SMOKE DETECTORS
Smoke detector must be latching type (ex. PG4926 Series)
To reset smoke detector, enter [
✱
][7][2]
TYPICAL ZONE CIRCUITS
CORBUS
Compatibility Identifier: HS2-1
Maximum Operating Voltage: 13.8
Maximum Circuit Resistance: 240 ohm (total)
NOTE: For ULC installations, please refer to the ULC Installation Information Sheet part#29002157.
firealarmresources.com
