6.0 Options
- 80 -
Option [302]: Unknown Account Trouble
Default (Enabled)
This trouble enables or disables unknown account signal reporting (not in the account table). When set to Enabled, the trouble is reported. When set to
Disabled, the trouble is not reported.
Enabled
Condition reported
Disabled
Condition not reported
NOTE: For UL Listed products, the permitted setting is Enabled.
Option [303]: Supervised Accounts Exceeded Trouble
Default (Enabled)
This trouble enables or disables reporting when the account table limit is exceeded by a new account trying to connect to a SG-DRL5-IP with a full
account table. When set to Enabled, the trouble is reported. When set to Disabled, the trouble is not reported.
Enabled
Condition reported
Disabled
Condition not reported
NOTE: The number of accounts permitted in the account table is dependent on the table size unlocked for the IP channel.
NOTE: For UL Listed products, the permitted setting is Enabled.
Option [304]: Transmitter Restore Trouble
Default (Enabled)
This trouble enables or disables reporting of a transmitter restoral condition on the line card. When set to Enabled, the trouble is reported. When set to
Disabled, the trouble is not reported..
Enabled
Condition reported
Disabled
Condition not reported
Option [305]: Transmitter Absent Trouble
Default (Enabled)
This trouble enables or disables reporting of a transmitter failure/absent condition on the line card. When set to Enabled, the trouble is reported. When
set to Disabled, the trouble is not reported..
Enabled
Condition reported
Disabled
Condition not reported
NOTE: The number of accounts permitted in the account table is dependent on the table size unlocked for the IP channel.
Option [306]:TX Swap Trouble
Default (Enabled)
This trouble enables or disables reporting of a transmitter swap condition on the line card. When set to Enabled, the trouble is reported. When set to Dis-
abled, the trouble is not reported..
Enabled
Condition reported
Disabled
Condition not reported
Option [307]:Invalid Report Trouble
Default (Enabled)
This trouble enables or disables reporting of an invalid report condition. A received signal is invalid if it has a bad checksum or encryption key miss-
match. When set to Enabled, the trouble is reported. When set to Disabled, the trouble is not reported..
Enabled
Condition reported
Disabled
Condition not reported
Option [308]:Transmitter Deleted Trouble
Default (Enabled)
This trouble enables or disables reporting when a transmitter account is deleted from the table. Setting the trouble to enabled signifies the trouble will be
reported; setting the trouble to disabled signifies the trouble will not be reported.
Enabled
Condition reported
Disabled
Condition not reported
S
G
-S
ys
te
m
5
O
pe
ra
ti
ng
M
anua
l
Содержание SG-System 5
Страница 68: ...6 0 Options 68 Automation Mode Diagrams FIGURE 6 1 Flow Diagram for Loop Mode 0 SG System 5 Operating Manual ...
Страница 69: ...6 0 Options 69 FIGURE 6 2 Flow Diagram for Fallback Mode 1 SG System 5 Operating Manual ...
Страница 70: ...6 0 Options 70 FIGURE 6 3 Flow Diagram for All Mode 2 SG System 5 Operating Manual ...
Страница 71: ...6 0 Options 71 FIGURE 6 4 Flow Diagram for IP Fallback Mode 3 SG System 5 Operating Manual ...