Tyco Security Products SG-System 5, Руководство по эксплуатации

Страница: 7 / 108

2.0 Introduction
- 7 -
2.1 SG-System 5 Overview
The SG-System 5 is a multi-platform receiver intended for remote monitoring of commercial fire and burglary systems. The SG-System 5 can monitor
up to 24 IP communication line cards (SG-DRL5-IP) to receive and process alarm data in up to 64 pre-programmed profiles per line card. The SG-Sys-
tem 5's real time clock date stamps all received alarm signals which are then transmitted to a central station computer via TCP/IP or RS-232 port; trans-
mitted directly to a printer using the serial printer port and/or TCP/IP; and viewed on the LCD of the front panel while the receiver is in the manual state.
Options can be programmed using a PC with SG-Systems Console or locally using the touchscreen LCD. Each shelf can house up to 24 SG-DRL5-IP
line cards.
2.1.1 CPM Redundancy
The SG-System 5 can be used in a redundant configuration using two SG-CPM5's, where the primary SG-CPM5 backs up to the secondary SG-
CPM5 and vice versa. Under normal conditions, the primary SG-CPM5 is active and outputs all signals to the printer and automation, while the sec-
ondary SG-CPM5 is in standby. If the primary fails, the secondary SG-CPM5 automatically switches to active (within 30 seconds) and starts out-
putting signals to the printer and automation. During the switchover from standby to active, signal reception is not affected because the SG-DRL5-IP is
still able to receive signals. The output to printer and automation is delayed by the length of time required to switch from standby to active.
2.1.2 Diagrams
FIGURE 2-1: SG-System 5 Front with Door Closed
3 4
5
1 2
1. Thumb screws to hold faceplate closed
2. Line card status indicators (top LED is watchdog, middle LED is status and bottom LED is network)
3. SG-CPM5 Status LEDs (from left to right: Console, Trouble, Network, Watchdog, Automation)
4. Quick HOME button
5. 7" resistive touch LCD screen
S
G
-S
ys
te
m
5
O
pe
ra
ti
ng
M
anua
l