Tyco Security Products SG-System 5, Руководство по эксплуатации

Страница: 35 / 108

4.0 Hardware Descriptions and Specifications
- 35 -
6. Fasten the thumb screws.
7. Insert the fan tray power cable.
4.3.3.2 Paddle Card Installation
To replace the SG-DRL5-IP paddle cards, follow these steps:
NOTE: If a paddle card is not already installed, please skip steps 1-3.
1. Remove the network cable.
2. Unfasten the thumb screw.
3. Slide the paddle card out of the SG-MLRF5.
4. Slide the new paddle card in the SG-MLRF5.
5. Screw in the thumb screw.
6. Replace the network cable.
4.3.3.3 EMMC Memory
The SG-DRL5-IP has an EMMC module that is used for the account table.
To replace the EMMC memory, follow these steps:
1. Unfasten the SG-DRL5-IP thumb screw.
2. Pull out the SG-DRL5-IP using the pull tab and remove from the rack completely.
3. Unfasten the two screws on the EMMC module.
4. Carefully lift the EMMC module off the board.
5. Place the new EMMC module on the board.
6. Secure the new EMMC to the SG-DRL-IP with the screws removed in step 2.
7. Install the SG-DRL5-IP back into the SG-MLRF5.
EMMC Memory Module
S
G
-S
ys
te
m
5
O
pe
ra
ti
ng
M
anua
l