Tyco Security Products SG-System 5, Руководство по эксплуатации

Страница: 39 / 108

4.0 Hardware Descriptions and Specifications
- 39 -
4.7 SG-UIB5 - User Interface
The SG-UIB5 is used to configure and interact with the system. The SG-UIB5 has a resistive touch screen that allows the user to ackowledge alarms
when the SG-System 5 is in manual and program the SG-CPM5. The SG-UIB5 must be connected to the SG-CPM5 in order to operate.
NOTE: The SG-MLRF5 ships with one LCD and the secondary LCD must be installed separately for the secondary SG-CPM5.
The SG-UIB5 displays:
l
Manual/Active/Standby
l
Troubles
l
The System time
l
User programmable LCD message
l
Hardware Diagnostics
l
SG-CPM5 Programming Options
FIGURE 4-15: SG-UIB5 LCD Module
4.7.1 SG-UIB5(LCD) Replacement
To replace the SG-UIB5, follow these steps:
NOTE: If an LCD is not installed but has a blank plate, these steps are completed in the initial setup above.
1. Unfasten the four nuts holding the LCD.
2. Lift off the ground strap.
3. Lift off the metal shield.
4. Unfasten the LCD cable holder and place aside.
5. Unclip the LCD cable buy pushing down.
6. Unplug the LCD power cable from the LCD.
7. Lift off the LCD board.
8. Remove the plastic sheet covering the new LCD.
9. Place the LCD onto the front plate.
10. Connect the power cable from the SG-MLRF5 to the LCD (tab up).
11. Attach the display cable.
12. Install the display cable holder with the two screws (both the display cable and the LCD power cable must be under this).
13. Insert a tie wrap around the LCD power cable and display cable.
14. Place the metal shield on top of the LCD.
15. Replace the ground strap.
16. Fasten all four nuts (do not over-tighten).
S
G
-S
ys
te
m
5
O
pe
ra
ti
ng
M
anua
l