6.0 Options
- 87 -
Option [405]: DNIS Replacement of RRLLL
Default (00) - RRLLL
When set to 00 (RRLLL), the SG-DRL5-IP outputs the RRLLL (Receiver number and line number).
When set to 01 (DNIS), the SG-DRL5-IP outputs the DNIS received from the transmitter instead of the RRLLL. This applies to all messages generated
by the transmitter (alarm signals, test transmissions, etc.) as well as any internally generated event messages by the receiver (unknown account, trans-
mitter restoral, encryption enabled, etc.). Any event that uses the account code of the transmitter has RRLLL replaced by the DNIS. For events gen-
erated with account 0000, RRLLL is not replaced with the DNIS.
Option [406]: SIM Number Output
Default (00) - Disabled
This option is available with cellular transmitters. When enabled, the received SIM number is output to the printer and automation. The message
includes the account number (up to 10 digits following option [404]) and the SIM number (21 digits). The automation software used with the receiver
must support (s) protocol via the Sur-Gard output format in order for this feature to work.
Available settings for SIM Number output:
00 (Disabled)
No SIM number output
01 (Printer & Automation)
SIM number output to printer and automation
02 (Printer Only)
SIM number output to printer only
03 (Automation Only)
SIM number output to automation only
The automation output is as follows:
sRRLLLAAAAAAAAAASSSSSSSSSSSSSSSSSSSSS
The printer output is as follows:
SG -RR-LLL-AAAAAAAAAA--SSSSSSSSSSSSSSSSSSSSS
Where:
s
is the protocol identifier
RRLLL
is the receiver and line number of the line card that received the event
A
is the 10-digit account number
S
is the SIM number of the transmitter that sent the event
Option [407]: Transmitter Encryption Enable
Default(00) - Disabled
For transmitters types that support remote enabling of the encryption setting, this option will allow encryption to be automatically enabled based on the
profile option.
A setting of Disabled(00) will disable encryption for all transmitters in the profile
A setting of Enabled(01) will enabled encryption for all transmitters in the profile
In the event that the account table is used to override the encryption setting, the change will be ignored because the profile option controls this function.
Accounts that do not allow for the remote programming of the encryption field cannot be programmed (example: TL250 is a static encryption key and
cannot have encryption programmed remotely via this function).
This is a dynamic option and will follow the profile setting it is assigned to, for the associated DNIS.
S
G
-S
ys
te
m
5
O
pe
ra
ti
ng
M
anua
l
Содержание SG-System 5
Страница 68: ...6 0 Options 68 Automation Mode Diagrams FIGURE 6 1 Flow Diagram for Loop Mode 0 SG System 5 Operating Manual ...
Страница 69: ...6 0 Options 69 FIGURE 6 2 Flow Diagram for Fallback Mode 1 SG System 5 Operating Manual ...
Страница 70: ...6 0 Options 70 FIGURE 6 3 Flow Diagram for All Mode 2 SG System 5 Operating Manual ...
Страница 71: ...6 0 Options 71 FIGURE 6 4 Flow Diagram for IP Fallback Mode 3 SG System 5 Operating Manual ...