2–2
Model 3480 Electrospray Aerosol Generator
M o u n t i n g t h e I n s t r u m e n t
The Electrospray has no special mounting requirements other than
providing good ventilation (see below). The cabinet has four non-
marking rubber feet that give the instrument a good grip on clean,
level surfaces. The rubber feet (Figure 2-1) are installed in the
cabinet using integrated #8-32 UNC threaded fasteners and can be
removed (by unscrewing) to allow other mounting fasteners to be
used.
Note
: If the cabinet is mounted to a plate, drill holes in the plate to
match the ventilation holes in the bottom of the cabinet or use
standoffs to raise the bottom of the cabinet at least ½ inch
(1.2 cm) above the mounting plate.
10.50 [266,7]
1.50 [38,1]
7.99 [202,8]
15.86 [402,8]
6.00 [152,4]
.68 [17,3]
.59 [15,0]
Figure 2-1
Bottom View of Electrospray Aerosol Generator Showing Location of Rubber Feet.
Feet can be removed to provide mounting points on cabinet. Dimensions are in
inches [mm].
Ventilation Requirements
The Electrospray cabinet is designed to be cooled by natural
convection of room air drawn through the bottom of the cabinet and
exhausted through the back of the cabinet.
The cabinet should be installed with at least 2-inch (50 mm)
clearance between the back panel and any other surface. Also, the
cabinet should be set on a clean, hard surface so that the intake air
can move freely under the base of the cabinet.
