Section 7 COPIER MANAGEMENT FUNCTIONS
7-34
●
Changing the management code
Perform the following procedure to change the management code
used by the copy manager.
IMPORTANT!
If you change the management code from its factory default, be sure
to keep some sort of record of the new management code. If, for any
reason, you forget the registered management code, you will need to
contact your service representative.
1
Display the “Machine default” screen.
(See “(2) Accessing the machine default settings” on
page 7-21.)
Inch specifications
Default setting
Default setting
Copy
default
Weekly
timer
Machine
default
Language
Management
End
BOX
Management
Bypass
setting
Document
Management
Print
report
Metric specifications
Default setting
Default setting
Copy
default
Machine
default
Language
Bypass
setting
Management
Week
timer
End
Hard Disk
Management
Document
Management
Print
report
2
Select “Management code change” [“Change MGMT code
with #”] in the settings list on the left side of the touch panel
and then touch the “Change #” key.
The “Management code change” [“Change MGMT code with
#”] screen will be displayed.
Inch specifications
Default setting
Machine default
Close
Default setting
Silent mode
Date/Time
Time difference
Management code change
Auto shut-off
Off
2001/10/30 14:02
GMT+08:00
6300
On
Default menu
Down
Change #
Setting mode
Up
Metric specifications
Default setting
Machine default
Silent mode
Date/Time
Time difference
Change MGMT code with #
Auto shut-off
Off
30/10/'01 14:02
GMT+08:00
6300
On
Up
Down
Change #
Close
Default setting
Default menu
Setting mode
3
Use the keypad to enter a new 4-digit management code.
Inch specifications
Management code change
Default setting - Machine default
Back
Close
A bl e t o c h a n g e m a n a g e m e n t c o d e. ( # key )
Metric specifications
Change MGMT code with #
A bl e t o c h a n g e m a n a g e m e n t c o d e. ( # key )
Default setting - Machine default
Back
Close
NOTE
If you want to quit the displayed setting without changing it, touch the
“Back” key. The touch panel will return to the screen in step 2.
4
Touch the “Close” key. The touch panel will return to the
screen in step 2.
5
Touch the “Close” key once again. The touch panel will return
to the “Default setting” screen.
6
Touch the “End” key. The touch panel will return to the
contents of the “Basic” tab.
Содержание DC 2075
