Toyota 02-8FDF15, Руководство оператора

Страница: 53 / 392

en-52
Battery electrolyte check
1. The battery electrolyte should be between
the upper and lower levels (10 to 15 mm
from the top of the plates).
2. If the electrolyte level is below the lower
level, remove the cap and add distilled
water to the upper level through the water
inlet port.
Caution Caution
Be sure to use distilled water for battery
electrolyte. Also, wear protective glasses
when working on the battery.
(1) Toe board
Torque converter oil inspection
1. Park the vehicle at a safe and level
ground, and stop the engine.
Caution Caution
Inspect with the parking brake pedal
engaged and the forks are lowered to the
ground.
2. Open the engine hood and remove the toe
board.
3. Extract the level gauge and wipe it with
clean cloth.
4. Insert the level gauge back to the hole
from which it is removed, and extract it
again to check if the oil level is between
the F and L lines on the level gauge.
Note:
• Perform inspections using the COLD side
of the level gauge before operating the
vehicle.
• The level gauge contains the inscriptions
“COLD” and “HOT” on either side. Con-
duct inspections using the “COLD” side
before operating the vehicle and when the
oil temperature is 40
°
or under. If you have
operated the vehicle and the oil temperature
is 60
°
or over, use the “HOT” side to con-
duct inspections after 30 seconds and
within five minutes after the engine is
stopped.
5. If the level is near or below the L line,
add oil to the F line.
(1)
COLD
HOT
Retightening of bolts and nuts
Retighten each bolts and nuts on the chassis
and load handling system.
Greasing mast and steering linkage
Grease in accordance with the lubrication
table.
Caution Caution
• Clean the grease fitting tips thoroughly
prior to greasing.
• After greasing, wipe off excess grease.
a. Dead-battery vehicle
b. Engine hanger
c. To frame
d. Booster cable
e. Rescue battery
When the battery is dead
When a booster cable is available, it is possible
to start the engine using the battery of another
vehicle.
Connect the booster cable following the
sequence of the illustration.
Make sure of (+) and (-) terminals of the cable
when connecting.
Caution Caution
• Connection (1): The (+) terminal of dead
battery.
• Connection (4): Use a frame apart from
the battery.
• Do not directly connect batteries to avoid
a danger of explosion. (An inflammable
gas generated from batteries may catch
fire.)
a
b, c
d
e
(1)
(2)
(3)
(4)
01_A5028-0EA04_En.fm 52 ページ ２０１２年１２月６日 木曜日 午後１２時４２分