Toyota 02-8FDF15, Руководство оператора

Страница: 14 / 392

en
en-13
Charge warning lamp
1. This lamp comes on to indicate an abnor-
mality in the charging system while the
engine is running.
2. If normal, the lamp comes on when the
ignition switch is turned to ON and goes
off when the engine starts.
3. If the lamp comes on while the engine is
running, stop immediately, park the vehi-
cle in a safe location, stop the engine and
after the engine has cooled down inspect
the fan belt for cuts or looseness, adjust it,
and restart the engine.
If lamp does not go off, the electrical sys-
tem may be faulty.
Please ask a Toyota dealer immediately
for inspection and repair.
OPS lamp
If the operator leaves the seat, the OPS lamp
will light up, indicating that the OPS System is
operating. (If the operator returns to normal
seating position within 2 seconds, loading can
be continued.) In such a situation, return the
control lever and lift lever to the neutral posi-
tion, then sit on the seat again.
Caution Caution
In the following cases, a malfunction may
have occurred to the OPS System. Park the
vehicle in a safe location and contact your
Toyota dealer to request an inspection.
• If the operator leaves the seat, the OPS
lamp does not light up.
• Even when the operator re-seats, the OPS
lamp does not turn off.
Water temperature gauge
Indicates the temperature of the engine cool-
ant.
1.
This gauge functions with the ignition
switch ON, and displays the coolant
water temperature from left to right in a
10-stage gradation scale.
2. The operator will be notified when the
water temperature is 115ºC or over
(above 8th stage), as the final two stages
at far right begin blinking. Again, when
the engine protection function activates
(for vehicles with Multifunction display:
Option), the entire gauge will start blink-
ing to inform the operator.
3. Temporary overheating may be caused by
coolant leakage, low engine coolant level,
loosened fan belt, or other problem in the
cooling system. Contact your Toyota
dealer to request an inspection.
Fuel gauge
(Excluding LPG models)
Indicates the amount of remaining fuel in the
fuel tank in terms of a 10-stage gradation scale.
The operator will be notified that remaining
fuel level is low when the two stages at far left
start blinking.
It takes some time for the indication to be sta-
bilized after refuelling and the ignition switch
is turned to ON.
Note:
• If the operating area is not level, atten-
tion must be paid because the correct
level may not be indicated.
• When the gauge begins blinking, refuel
as soon as possible.
• In case of diesel engine, be sure to refuel
it before it runs out because when this
occurs it becomes necessary to bleed air
from the fuel supply system.
01_A5028-0EA04_En.fm 13 ページ ２０１２年１２月６日 木曜日 午後１２時４２分